RIDGID MS 1065LZ manual Miter Lock Plate

ADJUSTMENTS

￿The edge of the square and the saw blade should be parallel as shown in figure 14.

￿If the front or back edge of the saw blade angles away from the square as shown in figures 15 and 16, adjust- ments are needed.

￿Loosen the socket head screws that secure the miter fence to the miter table. See Figure 13.

￿Rotate the miter fence left or right until the saw blade is parallel with the square.

￿Retighten the screws securely and recheck the blade-to- fence alignment.

￿Insert the throat plate, lower the blade and secure with the screws. Tighten firmly. See page 18 for instruction regarding Òcutting a slot in the zero clearance throat plateÓ.

Your saw has scale indicators. After squaring adjustments have been made, it may be necessary to loosen the indicators screws and reset them to zero. See Figure 17.

MITER	BLADE
FENCE

MITER

LOCK PLATE

	FRAMING
MITER	SQUARE	MITER
TABLE		LOCK HANDLE
	VIEW OF BLADE
	SQUARE WITH FENCE	Fig. 14

50												50
4											4	5
5
40											40
35										.625	35
31.
625	30									31
										30
	25	22.5							.5	25
			20						22
									20
			15	5	1	1 2	1 2	1	15
							0		5

INDICATOR

MITER

FENCE

BLADE

MITER FRAMING

TABLE SQUARE

VIEW OF BLADE NOT SQUARE WITH

FENCE, ADJUSTMENTS ARE REQUIRED

Fig. 15

MITER

FENCE

BLADE

FRAMING

MITER SQUARE

TABLE

VIEW OF BLADE NOT SQUARE WITH

FENCE, ADJUSTMENTS ARE REQUIRED

Fig. 16

INDICATOR

SCREW

BEVEL

SCALE

SCREW

MITER SCALE

SCALE

SCALE

INDICATOR

INDICATOR

INDICATOR

POINT

Fig. 17

16