Chicago Electric 68104 manual Tool Set Up, Operating Instructions, To Prevent Serious Injury

Page 6

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

TO PREVENT SERIOUS INJURY

FROM ACCIDENTAL OPERATION:

Release the Trigger and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.

TO PREVENT SERIOUS INJURY:

DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED. Moving guards must move freely and close instantly.

To Remove or Install a Cut-Off Wheel

1.Raise the Saw if it is locked down by pushing down on it and pulling out the Lock Ball (21).

2.Open the Movable Guard (40) and tighten the Bolt (39) to secure it while working on the Wheel.

3.Push in the Spindle Lock Pin towards the Fixed Guard as shown in Figure F. Rotate the wheel until the Lock Pin slides into place.

Spindle

Lock Pin

(61)

Figure F: Spindle Lock Pin

4.While continuing to hold down the Spindle Lock Pin, use the Wrench (92) to remove the Arbor Bolt (41).

Cut-off

Wheel (44)

Arbor

Bolt (41)

Spindle Lock

Pin (61)

Wrench

(92)

Figure G: Removing Cut-off Wheel

5.Remove the Arbor Bolt (41), Arbor Washer (42), Outer Flange (43), and Cut-off Wheel (44).

Cut-off

Outer

Arbor

Arbor

Wheel (44)

Flange (43)

Washer (42)

Bolt (41)

Figure H: Removing Wheel

Page 6

For technical questions, please call 1-800-444-3353.

SKU 68104

Image 6
Contents Save this Manual Email our technical support at tech@harborfreight.comTable a Recommended Minimum Wire General Tool Safety WarningsSpecifications Save This ManualGrounding Pin 110-120 V~ Grounded Tools Tools with Three Prong PlugsGrounding Instructions For up to 125 V~ and up to 15 aGrinder Safety Warnings Vibration SafetyLock Ball Depth Bolt Nut Instructions for Putting into UseBall Angle Vise Quick Guide Release CrankTo Prevent Serious Injury From Accidental Operation Tool Set UpOperating Instructions To Prevent Serious InjuryWork Piece and Work Area Set Up General Operating InstructionsArbor Bolt Washer Outer Flange Cut-off Wheel Inner Flange Cut-off Wheel Storage and Handling Cleaning, Maintenance, and LubricationMaintenance and Servicing To Prevent Serious Injury from Tool FailureTroubleshooting Problem Possible Causes Likely SolutionsParts List Part DescriptionAssembly Diagram Limited 90 Day Warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800