Troubleshooting

Problem		Possible Causes		Likely Solutions
Tool will not start.	1.	Cord not connected.	1.	Check that cord is plugged in.
	2.	No power at outlet.	2.	Check power at outlet. If outlet is unpowered,
				turn off tool and check circuit breaker. If breaker
				is tripped, make sure circuit is right capacity
				for tool and circuit has no other loads.
	3.	Tool’s thermal reset breaker	3.	Turn off tool and allow to cool.
		tripped (if equipped).		Press reset button on tool.
	4.	Internal damage or wear.	4.	Have technician service tool.
		(Carbon brushes or
		switch, for example.)
Tool operates slowly.	Extension cord too long or		Eliminate use of extension cord. If an extension cord
	wire size too small.		is needed, use one with the proper diameter for its
			length and load. See Table A on page 2.
Performance	1.	Cut-off Wheel worn.	1.	Replace Cut-off Wheels as needed.
decreases over time.	2.	Carbon brushes worn	2.	Have qualified technician replace brushes.
		or damaged.
Excessive noise	Internal damage or wear. (Carbon		Have technician service tool.
or rattling.	brushes or bearings, for example.)
Overheating.	1.	Forcing machine to work too fast.	1.	Allow machine to work at its own rate.
	2.	Blocked motor housing vents.	2.	Wear ANSI-approved safety goggles and
				NIOSH‑approved dust mask/respirator while
				blowing dust out of motor using compressed air.
	3.	Motor being strained by long or	3.	Eliminate use of extension cord. If an extension cord
		small diameter extension cord.		is needed, use one with the proper diameter for
				its length and load. See Table A on page 2.

Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply before service.

SKU 68104

Page 9

Problem