ADJUSTING BLADE PARALLEL TO TABLE SLOT
1.DISCONNECT THE SAW FROM THE POWER SOURCE.
2.NOTE: This adjustment should be checked with the cutting arm moved all the way to the right (blade 90 degrees to the table).
3.Lower the cutting arm. The saw blade (A) Fig. 25, should be parallel to the left edge (B) of the table insert opening.
4.If an adjustment is necessary, loosen two screws
(C) Fig. 25, and move the cutting arm until the blade is parallel with the left edge (B) of the table insert opening. Then tighten two screws (C).
A
B
Fig. 25
ADJUSTING FENCE 90 DEGREES TO BLADE
1.DISCONNECT THE SAW FROM THE POWER SOURCE.
2.NOTE: This adjustment must be made with the fence in both the forward and rear position.
3.Loosen the two fence locking screws, one of which is shown at (A) Fig. 26, and move the fence (B) all the way to the forward position, as shown. Then tighten the two fence locking screws (A).
4.Lower the saw blade and lock the cutting arm in the down position.
5.Using a square (C) Fig. 27, place one end of the square against the blade and the other end against the table, as shown. Check to see if the fence is 90 degrees to the blade.
6.If an adjustment is necessary, loosen the two fence locking screws (A) Fig. 26, and turn the two adjusting screws, one of which is shown at (D) Fig. 26, until you are sure fence is at 90 degrees to the blade when the fence is all the way forward and tighten the two fence locking screws (A) Fig. 26.
B
A
D
Fig. 26
C
Fig. 27
13