Delta 36-220 Typical Operations and Helpful Hints, Adjusting Downward Travel of SAW Blade

Page 15

ADJUSTING DOWNWARD TRAVEL OF SAW BLADE

1.DISCONNECT THE SAW FROM THE POWER SOURCE.

2.The downward travel of the saw blade can be limited to prevent the saw blade from contacting any metal sur- faces of the machine. This adjustment is made by loos- ening locknut (A) Fig. 31, and turning adjusting screw (B) in or out.

3.When making this adjustment, make sure the machine is disconnected from the power source and lower the blade as far as possible. Rotate the blade by hand to make certain the teeth do not contact any metal surfaces.

A

B

Fig.31

TYPICAL OPERATIONS AND HELPFUL HINTS

1.Before cutting, make certain the miter and bevel angles are set and firmly locked in place.

2.Before cutting, determine that the workpiece is the right size for the saw.

3.Place the workpiece on the table and hold it firmly against the fence.

4.For best results cut at a slow, even cutting rate.

5.If the workpiece you are cutting causes your hand to be within 4 inches of the saw blade the workpiece must be clamped to the fence before cutting.

6.Never attempt any freehand cutting (wood that is not held firmly against the fence and table).

7.Fig. 32, illustrates the fence in the rear position

enabling you to cross-cut a standard 2 x 6 in one pass.

8.Fig. 33, illustrates the stock stop (A) being used for repetitive cutting operations.

Fig. 32

A

Fig. 33

15

Image 15
Contents Compound Miter Saw Always Wear EYE Protection Safety RulesAdditional Safety Rules for Compound Miter Saws Extension Cords Connecting Compound Miter SAW To Power SourceAssembly Instructions Operating Instructions ForewordUnpacking Assembling Lower Blade Guard Link Assembling Stock Stop and Table Extensions Assembling Accessory Work Clamp to SAW Fastening Compound Miter SAW To Supporting SurfaceAssembling Dust BAG Starting Stopping SAW Operating ControlsTilting Cutting ARM for Bevel Cutting Rotating Table For Miter CuttingTWO Position Fence Locking Cutting ARM Down PositionAdjusting 90 and 45 Degree Bevel Stops AdjustmentsAdjusting Fence 90 Degrees to Blade Adjusting Blade Parallel to Table SlotAdjusting Sliding FIT Cutting ARM Vertical Travel Typical Operations and Helpful Hints Adjusting Downward Travel of SAW BladeCutting Crown Moulding Auxiliary Wood Fence Changing the Blade MaintenanceBrush Inspection Replacement PARTS, Service or Warranty Assistance AccessoriesPage Page Canadian PORTER-CABLE Delta Service Centers