Powermatic PM2800B operating instructions Lamp replacement

Page 17

7.Shut off drill press and disconnect from power.

8.Remove lower belt in same manner as upper belt.

9.Use reverse procedure to install new belts.

11.2Lamp replacement

Referring to Figure 28:

1.To replace a lamp, use a thumbnail or flat blade screwdriver to gently pry down the lamp assembly (A) until it releases from the seat, as shown.

2.Unscrew front plate (B) from head, pull out the plate, and disconnect the lamp wires from the electrical board. Remove old lamp assembly.

3.Install new lamp assembly and push it firmly into the seat. Connect the wires and reinstall front plate.

Figure 28

17

Image 17
Contents Inch Variable Speed Drill Press Warranty Period Warranty and ServiceTable of contents Safety warnings About this manual Subject to local/national electrical codes SpecificationsBase Hole Centers for PM2800B Shipping contents Setup and assemblyTools required for setup Unpacking and cleanupPage Table insert leveling Grounding instructions Electrical connectionsVoltage conversion AdjustmentsExtension cords Table movementChanging spindle speeds Chuck and arbor removalDepth stop Work stopLaser adjustment Operating controls Installing bitsOperation Positioning work pieceSetting rotation speed MaintenanceBelt replacement General InspectionLamp replacement Replacement Parts Troubleshooting the PM2800B Drill PressExploded View for PM2800B Description Size Qty Part List for PM2800BLead Wire Assembly, on/off switch to circuit board Head Casting s/n 1308001 and higher 226 PM2800-037 Drive Screw Electrical Connections for PM2800B Drill Press