SECTION 5: SERVICE PROCEDURES

WASH MOTOR REPLACEMENT

Jackson glasswasher machines come equipped with

 

wash pumps that have powerful motors attached to them to

 

ensure proper ware washing results. Occasionally, these

STEPS

assemblies may require replacing to maintain optimum perfor-

mance.

Jackson offers all of the repair parts necessary for performing this task.

The instructions provided here are for maintenance personnel only. Unauthorized persons should not attempt any of the steps contained in these instructions.

Warning: many of the instructions and steps within this document require the use of tools. Only autho- rized personnel should ever perform any maintenance procedure on the dishmachine!

PREPARATION

1.Power must be secured to the unit at the service breaker. Tag or lock out the service breaker to prevent acci- dental or unauthorized energizing of the machine.

2.Ensure that incoming water to the machine is secured either by use of a shut-off valve or disconnecting the incoming water line.

3.The unit must be drained completely with the drain stopper removed.

1. To access the assembly, you need to get access to the rear

of the unit. This mayGain accessrequireto thethatrearwater,of the drainmachineand. power lines be disconnected so that the unit can be moved for access.

TOOLS REQUIRED

The following tools will be needed to perform this maintenance evolution:

1.1/4” Nutdriver

2.5/16” Nutdriver

3.Needlenose Pliers

4.7/16” Combination Wrench

5.(2) 9/16” Combination Wrench

TIME REQUIRED

It is estimated that it will take (1) person ninety min- utes per motor to perform this task, not including all of the items indicated in the section entitled “PREPARATION”.

IMPORTANT NOTES

1.Read these instructions thoroughly before attempt- ing this maintenance task. Become familiar with the parts and what actions need to be taken. This will save time in the long run!

2. Using the 5/16” nutdriver, loosen the clamps on the suction

hose.

Loosening the suction hose clamps.

3.Using the same nutdriver, loosen the disharge hose where it connects to the tub weldement.

4.Pull the discharge hose out and away from the tub.

5.Remove the motor assembly mounting nuts using the 7/16”

Delta 1200 Technical Manual 07610-003-62-15 G

Issued: 10-27-2008 Revised:05-21-2012

25

Page 30
Image 30
Jackson Delta 1200, Chemical Sanitizing Glasswasher Dishmachine Series Service Procedures, Wash Motor Replacement