Jet Tools JDP-12 operating instructions Features and Controls, Lubrication, Basic Operation

Page 13

Figure 11

Features and Controls

Refer to Figure 11:

Downfeed Handle – Lower and raise drill. Lamp Switch – Turns lamp on and off. Laser Switch – Turns laser on and off.

Spindle Speed Adjustment Handle – Used to set spindle speed from 500 to 3000RPM. Machine must be on when making adjustment.

Start/Stop Switch – Pull switch to start; push to stop. Removing key (yellow) will prevent machine from being started. Key can be removed while machine is in operation, but machine will not restart until key is reinserted

Table Height Adjust Handle – Raises and lowers table; column lock handle must be unlocked.

Table Lock Handle – Unlocking permits rotation of table.

Lubrication

Periodically lubricate the gear and the rack, the table elevation mechanism, the splines (grooves) in the spindle, and the teeth of the quill with #2 tube grease.

Basic Operation

ˆAlways use a back-up piece of scrap wood to cover the table. This protects both the table and the drill bit.

ˆPlace material to be drilled in such as way as to come into contact with the left side of the column. This prevents the material from spinning.

If the work piece is not large enough to come into contact with the column, use a clamp or drill press vise that is securely fastened to the table!

Failure to comply may cause serious injury!

ˆFeed the bit into the material with only enough force to allow the drill bit to work. Feeding too slowly may cause burning of the workpiece. Feeding too quickly may cause the motor to stop and/or the drill bit to break.

Generally speaking, the smaller the drill bit, the greater the RPM required. Wood requires higher speeds than metal. Metal is usually drilled at slower speeds.

ˆIn dusty environments, frequently blow out any dust that accumulates inside the motor.

13

Image 13
Contents Variable Speed Drill Press Warranty Period Warranty and ServiceTable of Contents Page Page Introduction Specifications Unpacking Contents of the Shipping ContainerHardware Base and Column Assembly AssemblyTable Height Adjust and Column Lock Handles Table and RackMounting the Head Installing the Chuck and ArborDownfeed Handles Grounding Instructions ElectricalVolt Operation Only Extension CordsAdjusting the Depth Stop AdjustmentsSpindle Speed Adjust Removing the Chuck and ArborLaser Adjustment Return Spring AdjustmentLubrication Features and ControlsBasic Operation Trouble TroubleshootingParts Ordering Replacement Parts Parts ListJDP12-PHA 103 JDP12-103 Assembly Drawing Wiring Diagram New Sanford Road LaVergne, Tennessee Phone
Related manuals
Manual 1 pages 59.3 Kb