Unpacking
Separate all parts from the packing material. Check each part against the Contents of the Shipping Container and make certain that all items are accounted for before discarding any packing material.
Contents of the Shipping Container
AHead Assembly (1)
BTable(1)
CBracket Assembly (1)
DBase (1)
EColumn and Rack Assembly (1)
FDownfeed Handle (3)
GArbor (1)
HDrift Key (1)
JChuck Key (1)
KColumn Lock Handle (1)
LTable Lock Handle (1)
Hardware
OM10 x 30 Hex Cap Screws (4)
PChuck (1)
QTable Extension Lock Knob (2)
RTable Height Adjust Handle (1)
Tools Supplied for Assembly
M3mm Hex Wrench
N5mm Hex Wrench
Tools Required for Assembly
17mm Box Wrench or a
Read and understand all assembly instructions before attempting assembly! Failure to comply may cause serious injury!
Before Assembly
1.Remove the contents from the shipping container.
2.Compare the contents of the shipping container with the list found above. Report any shortages or damage to your JET distributor.
3.Clean all rust protected surfaces with kerosene or a light solvent. Do not use lacquer thinner, paint thinner, or gasoline.
These will damage plastic components and painted surfaces.
Contents of Shipping Container
Hardware
7