Jet Tools JDP-12 operating instructions

Page 5

24.Maintain a balanced stance at all times so that you do not fall or lean against the spindle or other moving parts. Do not overreach or use excessive force to perform any machine operation.

25.Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for which it was not designed. The right tool will do the job better and safer.

26.Use recommended accessories; improper accessories may be hazardous.

27.Maintain tools with care. Keep drill bits sharp and clean for the best and safest performance. Follow instructions for lubricating and changing accessories.

28.Disconnect tools before servicing; when changing accessories, such as blades, bits, cutters and the like.

29.Make sure the work piece is securely attached or clamped to the table. Never use your hand to hold the work piece.

30.Turn off the machine before cleaning. Use a brush or compressed air to remove chips or debris — do not use your hands.

31.Do not stand on the machine. Serious injury could occur if the machine tips over.

32.Never leave the machine running unattended. Turn the power off and do not leave the machine until it comes to a complete stop.

33.Remove loose items and unnecessary work pieces from the area before starting the machine.

Familiarize yourself with the following safety notices used in this manual:

This means that if precautions are not heeded, it may result in minor injury and/or possible machine damage.

This means that if precautions are not heeded, it may result in serious injury or possibly even death.

5

Image 5
Contents Variable Speed Drill Press Warranty Period Warranty and ServiceTable of Contents Page Page Introduction Specifications Hardware Contents of the Shipping ContainerUnpacking Base and Column Assembly AssemblyTable Height Adjust and Column Lock Handles Table and RackDownfeed Handles Installing the Chuck and ArborMounting the Head Grounding Instructions ElectricalVolt Operation Only Extension CordsAdjusting the Depth Stop AdjustmentsSpindle Speed Adjust Removing the Chuck and ArborLaser Adjustment Return Spring AdjustmentBasic Operation Features and ControlsLubrication Trouble TroubleshootingParts Ordering Replacement Parts Parts ListJDP12-PHA 103 JDP12-103 Assembly Drawing Wiring Diagram New Sanford Road LaVergne, Tennessee Phone
Related manuals
Manual 1 pages 59.3 Kb