Jet Tools JDP-12 operating instructions Introduction Specifications

Page 6

Introduction

This manual is provided by JET covering the safe operation and maintenance procedures for the JET JDP-12 Drill Press with Digital Readout. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or JET. JET can also be reached at our web site: www.jettools.com.

Specifications

Model Number

JDP-12

Stock Number

707300

Swing

12”

Type

Bench Top

Drilling Capacity

5/8”

Chuck Size

5/8”

Spindle Travel

3-1/8”

Spindle Distance to Base

23-1/2"

Spindle Distance to Table (max.)

17”

Table Size Diameter (width x depth)

9-1/2" x 9-1/2"

Table Tilt

+ or - 45°

Spindle Taper

MT-2

Column Diameter

2-1/2"

Number of Spindle Speeds

Variable

Range of Spindle Speeds

530-3000 RPM

Light Bulb

40W max.

Overall Height

37"

Base Size

11-1/2" x 16-1/2"

Motor

115V only, 1/3HP, 1 Ph, 5A

Net Weight (approx.)

88 lb.

Shipping Weight (approx.)

93 lb.

The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.

Read and understand the entire contents of this manual before attempting assembly or operation! Failure to comply may cause serious injury!

6

Image 6
Contents Variable Speed Drill Press Warranty and Service Warranty PeriodTable of Contents Page Page Introduction Specifications Contents of the Shipping Container UnpackingHardware Table Height Adjust and Column Lock Handles AssemblyBase and Column Assembly Table and RackInstalling the Chuck and Arbor Mounting the HeadDownfeed Handles Volt Operation Only ElectricalGrounding Instructions Extension CordsSpindle Speed Adjust AdjustmentsAdjusting the Depth Stop Removing the Chuck and ArborReturn Spring Adjustment Laser AdjustmentFeatures and Controls LubricationBasic Operation Troubleshooting TroubleOrdering Replacement Parts Parts List PartsJDP12-PHA 103 JDP12-103 Assembly Drawing Wiring Diagram New Sanford Road LaVergne, Tennessee Phone
Related manuals
Manual 1 pages 59.3 Kb