REMOVAL AND INSTALLATION METHOD OF BATTERY
Handle
Insert
Latch
Push
Battery
Pull Out
Fig. 9
◯How to remove the battery. Hold the handle tight.
Press the latch located at the front of the battery and pull out the battery. (Fig. 9)
◯How to install the battery.
Position the battery so that the latch faces toward the switch trigger in the handle and insert the battery. (Fig. 9)
CHARGING METHOD
Battery
Nameplate
Ventilation Slots
Pilot Lamp
< UC12Y >
Battery
Nameplate
Pilot Lamp
<UC14YF / UC14YF2 > Fig. 10
NOTE:
Before plugging into the receptacle, make sure the following points.
◯The power source voltage is stated on the name- plate.
◯The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn up.
1.Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been in- serted into the receptacle, pilot lamp will blink in red. (At
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.
2.Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 10.
Make sure it contacts the bottom of the battery charger.
14