Craftsman 315.11196 owner manual To Charge, Sea Figure

Page 7

WARNING: Always wear safety goggles or safety glasses with side shields when operating

tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.

,_ WARNING: Do not allow familiarity with your drill-driver to make you careless. Remember that

acareless fraction of a second is sufficient to inflict severe injury.

CHARGING BATrERY PACK

The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it at least 5 hours prior to use.

Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by recharging) for them to become fully charged.

TO CHARGE

Charge battery pack only with the charger and charging stand provided.

Connect charger to charging stand by inserting charger plug into input jack. See Figure 1.

Make sure power supply Is normal house voltage, 120 volts, 60 Hz, AC only.

Connect charger to power supply.

Place battery pack in charging stand. Align raised

 

rib on battery pack with groove in charging stand.

 

 

Sea Figure I.

 

Press down on battery pack to be sure contacts on

 

 

battery pack engage properly with contacts in

H

 

charging stand.

When properly connected, the red light on charging

 

stand will turn on.

Note: If charger does not charge battery pack,

 

return battery pack, charging stand, and charger to

 

your nearest Sears Repair Center for electrical

 

check.

After normal usage, 3 hours of charging time is

required to be fully charged. A minimum charge

 

time of 5 hours is mquirsd to recharge a completely

 

 

discharged tool.

 

The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.

Do not place charger in an area of extreme heat or cold. It will work best at normal room temperature.

CAUTION: Your battery pack contains special high temperature batteries to help prevent battery

damage when left on charge for extended periods of time. However, once the batteries become fully charged, we recommend that you unplug your charger from power supply and remove the battery pack.

7

Image 7
Contents CRAFTSMAN+ Specifications Guard Symbol Meaning Safety Alert SymbolRemove Adjusting Keys Read ALL InstructionsDo not Charge Battery Tool in a Damp or WET Location Important Safety Rules for Battery ToolsDo not USE Tool if Switch does not Donot Place Battery Tools or TheirImportant Information for Recharging HOT Batteries Rules Forsafe Operation ContlnuedKnow Your DRILL-DRIVER Keyless Chuck Battery Wrist StrapSea Figure To ChargeSelector Forward SwitchLock Selector Switchtrigger Variable Speed Switch LockDepresslatchesto To Remove Battery PackReleasebatterypack Keyless ChuckRemoving Bits Installing BitsRight Chuckbody Drillbit Chuckjaws ChuckcollarTo Decreaseadjusting Torquering Toincrease Level Drilling To Adjust TorqueDrilling Chuck RemovalMallet Keyless Chuck Jaws Allen To Retighten a Loose Chuck CHUCKREMOVALcoInuedPreparation for Recycling BAnERIESKEY Part Number Description Quan See Back page for Parts Ordering InstructionsSF.AR$