REVERSIBLE
See Figure 3.
This tool has the feature of being reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked.
VARIABLE SPEED
See Figure 3.
This toot has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.
This drill has an electric brake. When the trigger switch is released, the chuck stops turning. When the brake is functioning properly, sparks will be visible through the vent slots on the housing. This is normal and is the action of the brake.
Note: You might hear a whistling or ringing noise from the switch during use. Do not be concerned, this is a normal part of the switch function.
FORWARD/REVERSE/LOCK
SELECTOR REVERSE
TO INSTALL BATTERY PACK
See Figure 4.
•Lock switch trigger on the drill by placing the direction of rotation selector in center position.See Figure 2.
•Place battery pack in the drill. Align raised rib inside drill with groove on battery pack.See Figure 4.
•Make sure the latches on each side of your battery pack snap into place and battery pack is secured in drill before beginning operation.
_i= CAUTION: When placing battery pack in the drill, be sure raised rib inside drill aligns with groove on
battery pack and latches snap in place properly. improper assembly of battery pack can cause damage to internal components.
BATTERYPACK
LATCHES
_DEPRESSLATCHESTO
FORWARD
VARIABLESPEED
SWITCHTRIGGER
Fig. 3
,_ CAUTION: To prevent gear damage, always allow chuck to come to a complete stop before changing the direction of rotation.
To stop, release switch trigger and allow the chuck to come to a complete stop.
RELEASEBATTERYPACK | Fig. 4 |
TO REMOVE BATTERY PACK
•Lock switch trigger on the drill by placing the direction of rotation selector in center position. See Figure 2.
•Locate latches on end of battery pack and depress to release battery pack from the drill. See Figure 4.
•Remove battery pack from the drill.
10