Craftsman 315.11445 manual Service, When servicing a tool, use only identical replace

Page 4

SERVICE

 

When servicing a tool, use only identical replace-

Tool service must be performed

only by qualified

ment parts. Follow instructions in the Maintenance

 

repair personnel. Service or maintenance performed

section of this manual. Use of unauthorized parts or

failure to follow

Maintenance Instructions may create a

by unqualified personnel may result in a risk of injury.

risk of shock or

injury.

 

Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring. Contact with a "live" wire will also make exposed metal parts of the tool "live" and shock the operator.

ADDITIONAL RULES FOR SAFE OPERATION

Know your power tool. Read operator's manual carefully. Learn its applications and limitations, as well as the specific potential hazards related to this tool. Following this rule will reduce the risk of electric shock, fire, or serious injury.

Always wear safety glasses with side shields. Everyday glasses have only impact resistant lenses. They are NOT safety glasses. Following this rule wilt reduce the risk of eye injury.

IMPORTANT RULES FOR BATTERY TOOLS

Battery tools do not have to be plugged into an electrical outlet; therefore, they are always in operating condition. Be aware of possible hazards when not using your battery tool or when changing accessories. Following this rule will reduce the risk of electric shock, fire, or serious personal injury.

Do not place battery tools or their batteries near fire or heat. This will reduce the risk of explosion and possibly injury.

Batteries vent hydrogen gas and can explode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately.

Do not charge battery tool in a damp or wet loca-

tion. Following this rule will reduce the risk of electric shock.

For best results, your battery tool should be charged in a location where the temperature is more than 50°F but less than 100°F. Do not store outside or in vehicles.

Under extreme usage or temperature conditions, battery leakage may occur. If liquid comes in contact with your skin, wash immediately with soap and water, then neutralize with lemon juice or vinegar. If liquid gets into your eyes, flush them with clean water for at least 10 minutes, then seek immediate medical attention. Following this rule will reduce the risk of serious personal injury.

4

Image 4
Contents OperatorsManual Use of this Product More pleasant Enjoyable You thoroughly Electrical Safety Model Battery Pack ChargerWork Area Tool USE and CareService When servicing a tool, use only identical replaceDo not charge battery tool in a damp or wet loca Section of this manual. Use of unauthorized parts orExtension cord must be used, make sure Symbol Name DESIGNATION/EXPLANATION Symbol MeaningBatterypack Chargingstand Shownintool Wrist Strap Variable SpeedDirection of Rotation Selector BIT StoragePacking List InstructionsMm Drill-driver Charging Battery Pack See FigureForward Variablespeed Switchtrigger Releasebatterypack To Remove Battery PackUnlockchuck Drillbit Releasecollar Lock Tighten Chuck Body Unlockchuck Drillbitcollar ChuckjawsBitstoragearea Screwdriver CUC J S Lock Tighten Chuck Body Adjusting To Adjust TorqueTo Decrease Ring Torque To Increase Drilling See Figures 12, 13, Mallet Chuck Jaws HEX KeykeylessBattery Pack Removal and Preparation BatteriesPage Volt Cordless DRILL-DRIVER Model See Back page for PartsMY-HOME