REMOVINGBITS
See Figure 7.
•Lock switch trigger or the drill by placing the direction of rotation selector in center position. See Figure 2.
•Loosen the chuck jaws from drill bit.
•To loosen: grasp and hold the collar of the chuck with one hand, while rotating chuck body with your other hand. Note: Rotate chuck body in the direction of the arrow marked UNLOCK to loosen chuck jaws.
•Do not use a wrench to tighten or loosen the chuck jaws.
•Remove drill bit from chuck jaws.
ADJUSTABLE TORQUE CLUTCH
See Figure 9.
The drill is equipped with an adjustable torque clutch for driving different types of screws into different materials. The proper setting depends on the type of material and the size of screw you are using.
TO ADJUST TORQUE
•Identify the twenty four torque indicator settings located on the front of the drill. See Figure 9.
•Rotate adjusting ring to the desired setting.
•1 - 4 For driving small screws.
5 - 8 For driving screws into soft material.
•9 - 12 For driving screws into soft and hard materials.
•13 - 16 For driving screws in hard wood.
•17 - 20 For driving large screws.
•21
| ADJUSTING |
TO DECREASE | RING |
TORQUE |
|
TO INCREASE |
|
TORQUE | Fig. 9 |
12