Variable Speed, BIT Storage, Wrist Strap

SPECIFICATIONS
Chuck	3/8 in. (10 mm) Keyless
Motor	14.4 Volt DC
Switch	Variable Speed
Gear Train	One Speed

Before using this tool, familiarize yourself with all operating features and safety requirements. However, do not let familiarity with the tool make you careless.

This new drill-driver is equipped with the following features. See Figure 1.

KEYLESS CHUCK

This tool has a keyless chuck that allows you to hand tighten or release drill bit in the chuck jaws.

SWITCH

The drill-driver has a conveniently located variable speed switch.

SWITCH LOCK

The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use.

No Load Speed		0-600/min.
Clutch		24	Positions
Charger	Input	120 V, 60 Hz, AC only
Charge	Rate		3-6 Hours
Torque		Maximum	100 in.lb.

VARIABLE SPEED

This toot has a variable speed switch that delivers higher speed with increased trigger pressure. Speed is controlled

by the amount of switch trigger depression.

FORWARD/REVERSE SELECTOR

(DIRECTION OF ROTATION SELECTOR)

The drill-driver has a forward/reverse selector located

above the switch trigger.

BIT STORAGE

When not in use, bits provided with the drill-driver can be placed in the storage area located on the rear of the motor housing.

WRIST STRAP

A wrist strap is provided to reduce the chances of drop- ping the drill-driver. Place one hand through the wrist strap when carrying toot.

TORQUEBIT STORAGE ADJUSTMENTRING

_SCREWDRIVERBITS

KEYLESSCHUCK

BATTERYPACK

FORWARD

REVERSE

SELECTOR

SWITCH

TRIGGER

RED

LIGHT

	BATTERYPACK
CHARGINGSTAND	SHOWNINTOOL	WRISTSTRAP	Fig. 1

SPECIFICATIONS