Recommended Nails to Use

The Auto-Hammer is versatile for use less than 7/16-in and lengths equal to for use with this Auto-Hammer.

Refer to below table for recommended

with a variety of nails. Nails with diameters or less than 2-1/2 in. are recommended

nails to use with:

NO.		Nail Type					Size	Shank	Head	Length
								Diameter	Diameter
1		Bright		Common			4d	0.1"	1/4"	1 1/2-in
2		Bright		Finish			6d	0.091"	9/64"	2-in
3		Bright		Finish			4d	0.072"	7/64"	1 1/2-in
4		Coated		Sinker			4d	0.08"	13/64"	1 3/8-in
5		Electro		Galvanized Roofing			4d	0.12"	1/4"	1 1/2-in
6		Hot tipped			Galvanized finish		10d	0.115"	3/8"	3-in
7		Tempered			Hard	Trim	6d	0.07"	9/64"	2-in
Recommended				Nailing		Materials for the Auto-Hammer
The Auto-Hammer may be
used for nailing into all types
of woods, wood-like materials,
and	plaster		board.
,_	Note:		The	tool	is not

suitable for nailing in hard metal or concrete.

Use of Nail Remover (Fig. 7)

Your Auto-Hammer comes with a 5-1/2" nail remover for use

with most finishing nails that can be used with this tool.

1.Slip the front tip underneath the nail head.

2.Pull out nails as shown in Fig. 7.

0924

Page 16

Materials for the Auto-Hammer