HAMMERING NAILS (Fig. 6) Fig. 6
1.Attach the battery pack to the
2.Secure the material to be nailed with clamps to keep it from turning when hammering.
3.Insert the head of the nail into the magnetic sleeve and up against the hammerhead, where it will be held in place by magnetism. Place the tip of the nail against
the workpiece.
4.Holding the shaft of the nail steady with your hand, push down on the tool and press the trigger switch to drive the nail far enough into the workpiece so that it stands on its own. Release trigger switch and remove your hand from the nail.
CAUTION: Be especially careful when driving shorter nails such as brads that you remove your hand as soon as the nail stands on its own in the workpiece.
5.Resume pushing down on tool and pressing trigger switch to continue hammering until the nail is fully driven into the workpiece. Near the end of hammering, the magnetic sleeve will retract to allow the hammerhead to drive the nail head flush to the workpiece.
WARNING: Do not force the hammer or apply side pressure. Hold the tool firmly; the tool will hammer the nail automatically.
61352 Manual_Revised_08 | 0924 | Page 15 |