DeWalt 550 specifications TRI Tool INC Tool Care

Page 4

TRI TOOL INC.

TOOL CARE

Maintain tools with care. Keep tools in good operating condition. Sharp tool bits perform better and safer than dull tool bits. Well maintained tools function properly when needed.

Check for damaged parts. If a tool has malfunctioned, been dropped or hit, it must be checked for damage. Run no-load tests and feed function checks. Do a com- plete visual inspection.

Electric motors. Use only with proper AC voltage power sources and observe all normal electric shock hazard procedures.

Do not abuse power and control cords. Pulling or running over cords and cables can result in electrical shock hazards and malfunctions. Keep control and power cords out of all cutting fluids and water.

Hydraulic drives. Observe proper procedures for electrically driven power sources. Avoid damage to hydraulic lines. Keep quick-disconnects clean. Grit contamination causes malfunctions.

Air tools. Check the exhaust muffler. Broken or damaged mufflers can restrict air flow or cause excessive noise. Use air motors only with a filtered, lubricated and regulated air supply. Dirty air, low-pressure air or over pressure air will cause mal- functions, including delayed starting.

AREA EQUIPMENT

Secure work. Whenever possible use clamps, vises, chains and straps to secure pipe.

Make sure the tool is secured; it is safer to have both hands free to operate the tool.

TOOL USE

Use the right tool and tool bit for the job. Do not use a tool, which is incorrect for the job you are doing.

Keep the tool bits fully engaged in the tool bit holders. Loose bits are a safety haz- ard.

4

92-0116 : Rev. 060810

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Rev Model 550 Tube Severing Tool Page Safety Precautions GeneralTRI Tool INC Tool Care Model 550 Tube Severing Tool General Description Specifications Model Tube Weight Size Maintenance Operation Model Tube Aluminum Stainless TitaniumConnecting and Disconnecting the Drive System to the Model TRI Tool INC Repairs and Replacement Replacement of the Cutter WheelTRI Tool INC AIR Drive Assembly Removal of a Sheared Roll PIN from the Drive AssyTrouble Shooting Problem The Tool Bit ChattersProblem There is a loss of air power Accessories Illustrated Parts Breakdown Parts List, Model 550-03, Tube Cutter P/N Part Description QtyParts List, Model 550-04, Tube Cutter P/N Parts List, Model 550-05, Tube Cutter P/N Parts List, Model 550-06, Tube Cutter P/N TRI Tool INC Model 550-08 Tube Severing Tool Assembly P/N Parts List, Model 550-08, Tube Cutter P/N HOUSING, Tube CutterModel 550-10, 12, 14 Parts List, Model 550-10, Tube Cutter P/N Parts List, Model 550-12, Tube Cutter P/N Parts List, Model 550-14, Tube Cutter P/N Parts List, Model 550-16, Tube Cutter P/N Model 550-18, 20, 24 and 28 Tube Severing Tool Assembly Parts List, Model 550-18, Tube Cutter P/N Parts List, Model 550-20, Tube Cutter P/N Parts List, Model 550-24, Tube Cutter P/N Parts List, Model 550-28, Tube Cutter P/N TRI Tool INC Model 550-32 Tube Severing Tool P/N Parts List, Model 550-32, Tube Cutter P/N TRI Tool INC Tube Cutter Drive Assembly P/N Parts List, Drive Assembly, Tube Cutter P/N Motor ASSEMBLY, CORDLESS, 14.4V 550 P/N Parts List, A10 Tool Kit not Shown Parts List, B1 Tool Kit not Shown Dewalt Safety Instructions
Top Page Image Contents