Ryobi BC400 manuel dutilisation Features, Operation, Product Specifications, Applications

Page 6

FEATURES

PRODUCT SPECIFICATIONS

Brush size

1 in. - 3 in.

Container size

1 gal.

KNOW YOUR paint brush cleaner

See Figure 2, page 8.

The safe use of this product requires an understanding of the information on the tool and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules.

Rating

120 V~, 1.2 Amps, 60 Hz

No Load Speed

950 r/min. (RPM)

INTERNAL BRISTLES - Soft, rotating bristles gently re- move oil, acrylic, varnish, and water-based paints from paint brushes.

ON/OFF SWITCH - This product has an easy access power switch located on the top of the product.

OPERATION

WARNING:

Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is suf- ficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.

WARNING:

Do not use any attachments or accessories not recom- mended by the manufacturer of this tool. The use of at- tachments or accessories not recommended can result in serious personal injury.

APPLICATIONS

You may use this tool for the purposes listed below:

Cleaning paint brushes

TURNING THE PAINT BRUSH CLEANER on and off

See Figure 3, page 8.

Plug in brush cleaner.

Push and release the on/off switch to start the paint brush cleaner.

Push and release the on/off switch again to turn the cleaner off.

OPERATING THE PAINT BRUSH CLEANER

See Figure 4, page 8.

Fill the bucket with warm water (for water based paints) or Klean Strip® White Formula Paint Thinner (for oil-based paints or varnish).

Set the cleaning assembly on the bucket. Secure in place using the latches.

Slip the paint brush into the opening at the top of the cleaning assembly.

Turn on cleaner.

After one or two minutes, turn off the cleaner and remove the paint brush.

NOTE: If the brush is still dirty, empty the bucket and repeat the above steps until the brush is clean.

6 — English

Image 6
Contents OPERATOR’S Manual Save this Manual for Future ReferenceWarranty Introduction Important safety instructions Read ALL InstructionsSymbols Name DESIGNATION/EXPLANATIONSpeed and Wiring ElectricalOperating the Paint Brush Cleaner FeaturesProduct Specifications OperationCleaning the Bucket MaintenanceGeneral Maintenance LubricationTable DES Matières GarantieInstructions importantes concernant la sécurité AvertissementLire toutes les instructions Symboles Symbole Signal SignificationVitesse ET Câblage Caractéristiques ÉlectriquesAVERTISSEMENT  Disjoncteur D’ÉLECTROMÉNAGERCaractéristiques UtilisationCommutateur Marche / Arrêt Lubrification EntretienEntretien Général Nettoyage du seauÍndice DE Contenido IntroducciónGarantía Instrucciones de seguridad importantes AdvertenciaLea todas las instrucciones Símbolos PeligroPrecaución Advertencia Partes EléctricasDispositivo DE Seguridad Instalado Dentro DEL Enchufe Alci Velocidad Y CableadoCaracterísticas FuncionamientoAplicaciones Lubricación MantenimientoMantenimiento General Limpieza DEL baldeLatches loquets, pestillos Page Page Page Paint Brush Cleaner ONE World TECHNOLOGIES, INC