MAINTENANCE
WARNING:
When servicing, use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage.
WARNING:
Always wear eye protection with side shields marked to comply with ANSI Z87.1 during product operation. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions.
Cleaning the BUCKET
Unplug the brush cleaner.
Remove the cleaning assembly from the bucket by lifting up and releasing the latches on each end of the unit.
Dispose of dirty water (or Klean Strip® White Formula Paint Thinner) in accordance with federal, state, and local ordinances.
Fill the bucket about
NOTE: Never use flammable chemicals or abrasive cleaning agents to clean the bucket.
Reattach the cleaning assembly to the bucket. Make sure the latches are closed.
Refill and repeat the procedure with clean water.
NOTE: It may be necessary to rinse the bucket more than once, then drain again as directed above.
Wipe the bucket with a clean, dry cloth.
Store tool indoors.
NOTE: Figures (illustrations) start on page 8 after
French and Spanish language sections.
7 — English