Panasonic C16P, FP0T32CP FP0 MEWNET-F Unit, Ne tworking Units, FP0-IOL Link Unit Specifications

FP0 MEWNET-F Unit

Ne tworking Units

MEWNET-F

The FP0 can be used as a slave station for MEWNET-F (remote I/O system) by adding I/O link unit.

MEWNET-F is a reduced-wiring, remote I/O system that connects PLCs located separately and I/O slave stations with 2-core cabling. By adding an I/O link unit to the FP0, you can link master station PLC and FP0 inputs and outputs via the network.

FP2 (Master station)

	Twisted pair cable or VCTF
FP0 (Slave station)	FP0 (Slave station)	FP0 (Slave station)
	FP0-IOL	FP0-IOL

FP0-IOL

	MEWNET-F Slave
	FP0-IOL
FP0-IOL Link Unit Specifications
Item	Description
Communication method	Two-wire, half duplex transmission
Synchronous system	Start stop synchronous system
Transmission line	2-wire cable (Twisted-pair cable or equivalent to VCTF 0.75 mm2 x 2C)
Transmission distance	Max. 700m per port (using twisted pair cable)
(Total distance)	Max. 400m per port (using VCTF cable)
Transmission speed (Baud rate)	0,5Mbit/s
Number of control I/O points	64 points
per an I/O link unit	(Input: 32 points. Output: 32 points)
Remote I/O map allocation	32X/32Y
Interface	Conforms to RS485
Transmission error check	CRC (Cyclic Redundancy Check) method

C-NET

By using C-NET, you can use multiple FP0s as data collection terminals.

By using the C-NET network and exclusive adapters, you can connect multiple FP0s by multi-drop connection with 2-wire cables. You can use computers for separate control or have network terminals for a centralised management system.

#.%4

ADAPTERP

3 TYPET !&0

&0

#.%4 !#  TO6 !&0
ADAPTERP 6$#	!&0	-AX UNITS

-AX M

12 07/2007