Network Setup

Make the various settings to use the network function.

SET UP	2/2
MULTI DISPLAY SETUP
MULTI PIP SETUP
PORTRAIT SETUP
SET UP TIMER
PRESENT TIME SETUP
NETWORK SETUP
DISPLAY ORIENTATION	LANDSCAPE

NETWORK SETUP

SAVE
DHCP	OFF

IP ADDRESS	192.168. 0.	8

SUBNET MASK	255.255.255.	0

GATEWAY	192.168. 0.	1

PORT	1024

LAN SPEED	AUTO

NETWORK ID	0

CONTROL I/F SELECT	RS-232C
MAC ADDRESS	--:--:--:--:--:--

DHCP, IP ADDRESS, SUBNET MASK, and GATEWAY settings

1 Set DHCP.

When “OFF” is selected, IP ADDRESS and other settings

can be set manually.

2 Select the item and press .

3 Enter an address.

	1	Use	to select a digit.
IP ADDRESS
I192.168. 0. 8	2	Use	to change a number.
	2	Use	to change a number.
	3	Press	.
	3	Press	.
	Pressing		will cancel the address
	change.

4 Select “SAVE” and press .

PORT setting

1 Select “PORT” and press . 2 Enter a port number.

PORT		1	Use	to select a digit.
PORT
	I01024	2	Use	to change a number.
		2	Use	to change a number.
		3	Press	.

English

SAVE

Save the current network Setup. Each value set for DHCP, IP address, Subnet mask, and Gateway will be saved. If “NG” is displayed, check the same IP address is not used within the same network.

DHCP (DHCP client function)

To obtain an IP address automatically using a DHCP server, set this to “ON”. If DHCP server is not used, set this to “OFF”.

IP ADDRESS (IP address display and setting)

Enter an IP address if DHCP server is not used.

SUBNET MASK (Subnet mask display and setting)

Enter a subnet mask if DHCP server is not used.

GATEWAY (Gateway address display and setting) Enter a gateway address if DHCP server is not used.

PORT

Set the port number used for command control. The available setting range is 1024 – 65535. When the PJLink™ protocol is used, the port setting is not necessary.

Pressing

will cancel the port

number change.

LAN SPEED

Set the connection speed of the LAN environment. Select the value from AUTO, 10 HALF, 10 FULL, 100 HALF or 100 FULL.

NETWORK ID

Set the ID to identify this unit.

The available setting range is 0 – 99.

CONTROL I/F SELECT

Set whether to control with RS-232C (serial) or LAN. When “LAN” is set, power indicator is lit orange when the slot power is turned on, then the power is turned “OFF” with remote control (stand- by state) regardless of the “Slot power” setting.

MAC ADDRESS

Display the MAC address of this unit. However, the MAC address is not displayed when the “CONTROL I/F SELECT” is set to “RS-232C”.

Notes:

• To use a DHCP server, make sure the DHCP server is started.

• Contact your network administrator for details on settings.