PJLink™ Protocol
The network function of the terminal board conforms with PJLink™ class 1 and you can operate the following actions from your computer using PJLink™ protocol.
•Display setup
•Display status query
Supported commands
Commands to control the display with PJLink™ protocol are shown in the table below.
| Command | Control | Remark |
| POWR | Power control | Parameter |
| 0 = Standby 1 = Power “On” | ||
|
|
| |
| POWR? | Power status query | Parameter |
| 0 = Standby 1 = Power “On” | ||
|
|
| |
| INPT | Input switch | Parameter |
| INPT? | Input switch query | First byte: 1 (RGB) fixed |
| Second byte: Input position (from 1) | ||
|
|
| |
| AVMT | Shutter control | Parameter |
|
|
| 10 = Picture On (picture mute deactivated), 11 = Picture Off (picture on mute) |
|
|
| 20 = Audio On (audio mute deactivated), 21 = Audio Off (audio on mute) |
|
|
| 30 = Shutter mode Off (picture and audio mute deactivated) |
|
|
| 31 = Shutter mode On (picture and audio on mute) |
| AVMT? | Shutter control query | Parameter |
|
|
| 11 = Picture Off (picture on mute) |
|
|
| 21 = Audio Off (audio on mute) |
|
|
| 30 = Shutter mode Off (picture and audio mute deactivated) |
|
|
| 31 = Shutter mode On (picture and audio on mute) |
| ERST? | Error status query | Parameter |
|
|
| First byte: Means fan error. 0 or 2. |
|
|
| Second byte: 0 |
English |
|
| Third byte: 0 |
|
| Sixth byte: Means other error. 0 or 2. | |
|
|
| Fourth byte: 0 |
|
|
| Fifth byte: 0 |
|
|
| Meaning of the 0 – 2 settings: |
|
|
| 0 = Error is not detected, 2 = Error |
| LAMP? | Lamp status query | Not supported |
| INST? | Input switch list query | Parameter |
|
|
| 11: Computer input |
|
|
| 12 - 16: Slot 1 input (INPUT1A) |
|
|
| Slot 1 input (INPUT1B) |
|
|
| Slot 2 input (INPUT2A) |
|
|
| Slot 2 input (INPUT2B) |
|
|
| Slot 3 input (INPUT3) |
|
|
| Numbers greater than 12 are depending on the slot installation condition |
| NAME? | Projector name query | Returns empty character (no name information) |
| INF1? | Manufacturer name query | Returns “Panasonic” |
| INF2? | Model name query | Returns |
| INFO? | Other information query | Returns version number |
| CLSS? | Class information query | Returns “1” |
PJLink™ security authentication
Set “Panasonic” for the PJLink™ password.
• PJLink™ is a pending trademark in Japan, the United States, and other countries or areas.
6