Command Control, Installing the Ferrite core

Using Network Function

Note:

To use the network function, set each “NETWORK SETUP” setting and make sure to set the “CONTROL I/F SELECT” to “LAN”. (see page 4)

When “LAN” is set, power indicator is lit orange when the slot power is turned on, then the power is turned “OFF” with remote control (stand-by state) regardless of the “Slot power” setting.

For details on the “Slot power” setting, refer to the Operating Instructions of the display unit.

■ Example of Network Connection

COMPUTER

Less

than 10 cm

	LAN cable	AUDIO PR/CR/R PB/CB/B Y/G
	LAN cable	LAN COMPONENT/RGB IN
	(not supplied)	LAN COMPONENT/RGB IN
	(not supplied)	Ferrite core
		(supplied)

Installing the Ferrite core

Ferrite core	Less	Open
(supplied)	than	Open
	10 cm

Pull back the tabs

Wind the cable

Press the cable

(in two places)

twice

through and close

Hub or broadband router

Notes:

•Lay the LAN cable away from other connection cables (excluding the power cord).

•Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.

•To connect a device using 100BASE-TX, use “category 5” LAN cable.

•Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.

Do not touch the LAN terminal or a metal part of the LAN cable.

•For instructions on how to connect, consult your network administrator.

Securing the LAN cable (TH-85PF12U)

When using a pedestal for the installation of the display, use a clamper

supplied with the display to secure the LAN cable. For use with another

method of installation, refer to the corresponding Installation Instructions.

Clamper

Note: In accordance with the Installation Instructions, secure the LAN cable so that it will not become near the display unit.

■Command Control

Network function of the unit can control the display in the same way as serial control from a network.

Supported commands

Commands used in the serial control are supported.

For details on serial control commands, refer to the Operating Instructions of the display unit.

Note:

Consult your local Panasonic dealer for detail instructions on command usage.

English