Insignia NS-32D510NA15 manual Connect an antenna or cable TV no box, Coaxial cable Connector

Insignia 32" LED TV

Connect an antenna or cable TV (no box)

Antenna or cable TV

(no box)

On your TV Coaxial cable

Coaxial cable

connector

ANT/CABLE IN

jack

Back of TV

1Make sure that your TV’s power cord is unplugged and all connected equipment is turned off.

2Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the back of your TV and to the antenna or cable TV wall jack.

3Plug your TV’s power cord into a power outlet, then turn on your TV.

4 Press INPUT to open the INPUT SOURCE list.

5 Press S or T to highlight TV, then press ENTER.

6If you cannot tune to channels you know exist, scan for channels. See “Automatically scan for channels” on page 55.

Notes

•Use a coaxial cable to eliminate interference and noise from radio waves.

•Do not bundle the coaxial cable with the power cord or other cables.

•If the antenna is not installed correctly, contact qualified service personnel to correct the problem.

•If the signal level for a channel is weak, the picture may be distorted. Adjust the antenna or use a highly directional outdoor or set-top antenna with a built-in amplifier.

•If the picture quality is good on some channels and poor on others, the problem may be caused by a poor or weak signal from the broadcaster or cable TV provider.

•If you connect to cable TV without a set-top box and experience poor picture quality, you may need to install a set-top box to improve signal reception and picture quality. Contact your cable TV provider about upgrading to a set-top box.

•Many high-definition (HD) channels upscale standard-definition (SD) content. The picture displayed on your TV is still displayed as SD, thus the picture quality will not be as clear or crisp as it would be if the content was originally recorded in HD.

18 www.insigniaproducts.com