Sharp AE-X28NCJ, AY-X28NCJ Introduction of Special Function, Temp Range Cool Mode Heat Mode Sleep

Operation of wireless remote control con’t.

Introduction of Special Function

●Press SLEEP button to select Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ), and cancel. Sleep cancel is default setting.

●Sleep 1 in Cool and Dry modes: after one hour, the main unit setting temperature will

increase 1°C. After 2 hours the setting temperature increases to 2°C, the unit will run at this setting temperature; In Heat mode: after two hours, the setting temperature will decrease 1°C, 2 hours, setting temperature will decrease 2°C , then the unit will run at this setting temperature.

	Temp Range	Cool Mode	Temp Range	Heat Mode
Sleep 2	16-23°C	+ 1°C every hour up to 3°C	16°C	N/A
	24-27°C	+ 1°C every hour up to 2°C	17-20°C	- 1°C after first hour
	28-29°C	+ 1°C every hour up to 1°C	21-27°C	-1°C every hour up to 2°C
	30°C	- 1°C after 7 hours	28-30°C	-1°C every hour up to 3°C

●Sleep 3

(1)Under Sleep 3 mode, press and hold "Turbo" button continuously, remote control enters into user individual sleep setting status. The time of remote control will display "1hour ", the setting temperature "88" will display the corresponding temperature of last sleep curve setting and blink

(2)To change the set temperature, adjust by pressing "" and " " buttons. Press "Turbo" button to confirmation;

(3)At this time, 1hour will be automatically increased at the timer position on the remote control, (that are "2 hours" or "3 hours" or " 8 hours "), the place of setting temperature “88” will display the corresponding temperature of last setting sleep curve and blink;

(4)repeat the above (2)～(3) operation, until 8 hours temperature setting finished, sleep curve setting finished, at this time, the remote control will resume the original timer display; temperature display will resume to the original timer display; temperature display will resume to original setting temperature.

●Sleep 3

The user could accord to sleep curve setting method to inquire the presetting sleep curve, enter into user individuation sleep setting status, but do not change the temperature, press "Turbo" button directly for confirmation.

Note: Sleep function can not be set under the Fan and Auto mode. Under Dehumidify mode, only Sleep 1 can be set. When selecting the Sleep mode function, the Quiet function is set automatically, different Quiet status could be optional and turned off.

8