INSTALLATION INSTRUCTIONS
INSTALLATION
WARNING: Make sure the unit is turned off and unplugged before working.
1 Cut the window sash foam seal (adhesive type) to the proper length and attach it to the underside of the window sash.
Jamb
Sill
Sash
Window sash foam seal (adhesive type)
Insert the right closure assembly and the | ||
2 left closure assembly into | the top | angle |
and the bottom channels. |
|
|
Secure the right and left | closure | to the |
cabinet with six of the provided screws. (L= 13/32", 10mm)
3 Open the window sash and place the air conditioner on the sill.
Balance the unit on the sill and close the window sash securely behind the top angle.
Closure assembly
WARNING:
At this step, make sure the unit is inclined approximately 1 cm (3/8") to the back.
If the unit is not properly inclined, the water collected in the bottom tray during opera- tion will not drain properly and may flow into the room where the air conditioner is in- stalled.
4 Insert the bottom gasket into the space between the window sill and the bottom of the unit to seal outside air.
sill
unit
incline backwards approximately 1cm (3/8")
If there is space between the bottom channel and the sill, fill the gap with a thin board or other hard filler.
Bottom gasket 
6