Cyclone MKV 2 Multimedia Adapter
To use the copy function of your media player, the device, or partition, that you want to copy the data onto must be formatted with one of the following file systems: FAT, FAT32, NTFS or ext3.
Please use only targets formatted with FAT, FAT32, NTFS or ext3 for copying onto. Otherwise you will receive an error message.
The player no longer responds:
If the Cyclone MKV 2 no longer responds to the remote control, the batteries may be dead. Please replace them with new ones.
Obstruction of the infrared’s field of vision may also cause unresponsiveness in the player. Please remove all potential obstructions between the player and remote control
Please clean the infrared receiver.
No audio output:
Please check that the volume for your TV, home entertainment system and Cyclone has not been set too low. Also check that the sound has not been switch off via the mute button.
The audio digital output may also be incorrectly configured.
If you have connected the media player via HDMI cable, please ensure that HDMI RAW, LPCM Dual Channel or LPCM
If you have connected the media player via optical cable, please ensure that SPDIF RAW or LCMP Dual Channel output is selected.
The player has failed during Firmware upgrade:
To recover the Cyclone MKV 2 from a firmware upgrade failure, power off the player and disconnect the power cable.
Insert a USB pen drive containing the firmware. Please note that only the firmware update files should be on the pen drive.
Connect the power cable back into the Cyclone MKV 2 and switch it on. This should cause the player to attempt to reinstall the software.
Page 40. Version 0.9