Cables to Go 29573 manual Verify Connection

Page 14

SOFTWARE/DEVICE INSTALLATION

VERIFY CONNECTION

To verify connection from Cable or PIN Association, you can open the Wireless USB host manager utility and you should have an icon displayed representing the TruLink Wireless VGA Device Adapter.

WIRED MODE

Your Wireless VGA Adapter can also be used wired mode.

1.Position the WIRELESS/WIRED switch in the WIRED position.

2.Plug the USB cable between your computer and the Wireless VGA Device Adapter. If not already installed, Windows will automatically install the necessary drivers.

3.If prompted to Accept Association, please do so, and then disconnect the USB cable. The function is the same as the wireless mode but data will be transferred through the USB cable and not use the Wireless USB host adapter. You are now ready to use your TruLink Wireless VGA Device Adapter.

13

Image 14
Contents User Guide Table of Contents Introduction Features System Requirements RAM 1GBPackage Contents PWR Power Indicator Device OverviewSOFTWARE/DEVICE Installation SOFTWARE/DEVICE Installation Important reboot/restart if prompted Figure Wireless USB Manager Do the following before installation You are now ready to use the adapter Figure Pin Association EntryVerify Connection Using the Wireless VGA Device Adapter Figure TruLink DisplayLink ManagerUsing the Wireless VGA Device Adapter Screen Rotation Screen ResolutionColor Quality Extend ToAdvanced Wireless USB Host Adapter Reset Frequently Asked Questions Why can’t I install .NET?Why is my video choppy? Video Playback Tips Technical Specifications QPSK/DCMCables to GO Warranty Statement Important Safety Information There are no User Serviceable PartsAppendix Appendix Cable Association Procedure Appendix Appendix PIN Association Procedure Figure Discovery Mode in Process PIN Change Procedure Appendix Appendix Appendix