Sharp FU-W53J operation manual Troubleshooting, Remedy not a malfunction

Page 15

TROUBLESHOOTING

Before calling for repair, please review the list below, since the problem may not be a unit malfunction.

SYMPTOM

REMEDY (not a malfunction)

Odours and smoke are not

• Clean or replace the filters if they appear to be heavily soiled.

removed.

(Refer to E-11, E-12)

The CLEAN-SIGN Light shows

• The air could be impure at the time the unit was plugged in. (Refer

green even when the air is im-

to E-5) Pull out the plug from the electrical outlet, and insert the

pure.

plug one minute later.

 

 

The CLEAN-SIGN Light shows

• The sensitivity of the sensors becomes unstable when the

yellow or red even when the air

opening of the odour sensor or dust sensor is dirty or is clogged.

is clean.

Clean the dust around the sensor opening using a vacuum

 

cleaner. (Refer to E-10)

 

 

A clicking or ticking sound is

• Clicking or ticking sounds may be audible when the unit is gen-

heard from the unit.

erating ions.

The discharged air has an aroma

• Check to see if the filters are heavily soiled.

Replace the filters.

or odour.

• Plasmacluster Air Purifiers emit small traces of ozone which

 

may produce an odour. These ozone emissions are well below

 

safety levels .

 

 

The unit does not operate when

• Is the unit installed in a location that is difficult for the sensor to

detect cigarette smoke?

cigarette smoke is in the air.

• Are the dust or odour sensor openings blocked or clogged?

 

(In this case, clean the openings.) (Refer to E-10)

 

 

The Plasmacluster Indicator

• Check to see if the Lights OFF Mode is selected. If so, then

Light or the CLEAN-SIGN Light

press the Light Control Button to activate the indicator lights.

will not activate.

(Refer to E-9)

 

 

If you still require service, contact your SHARP approved service centre.

SHARP approved service centre locations can be found in the support area of our website: Australia : http://www.sharp.net.au

New Zealand : http://www.sharp.net.nz

ERROR DISPLAY

LAMP INDICATION

REMEDY

 

Fan motor disconnected or abnormal.

The “Silent” Fan Speed Indica-

Operation stops.

• Pressing the POWER ON/OFF button will reset the error dis-

tor Light blinks.

play, but if error occurs again, contact the shop where you

 

purchased the unit.

 

 

ENGLISH

E-13

Image 15
Contents FU-W53J Please read before operating your new Air Purifier English Important Safety Instructions Installation Guidelines Main Unit Display Part NamesIncluded Filter Installation Remove the Front PanelRemove the Filter Support Place the Hepa Filter into Main unitReplace the Front Panel Main Unit Operation Power ON/OFF ButtonION Shower Mode Button OperationLights Control Button Plasmacluster ON/OFF ButtonCare and Maintenance Main UnitFilter Hand Wash only Do not Tumble DRY Washable Active Carbon Filter CareHepa Filter / Washable Active Carbon Filter Filter Replacement GuidelinesRemedy not a malfunction TroubleshootingStandby Power SpecificationsMemo Memo Memo Sharp Corporation of NEW Zealand Limited