Sharp FU-W53J Filter Installation, Remove the Front Panel, Remove the Filter Support

Page 8

PREPARATION Be sure to remove the power plug from the wall outlet.

FILTER INSTALLATION

To maintain the quality of the filters, they are installed in the main unit and packed in plastic bags. Be sure to remove the filters from the plastic bags before using the unit.

1

1

Remove the filters

Front Panel

Remove the Front Panel.

Pull the Front Panel on the lower sides, and lift up.

2 Remove the Filter Support.

Push in the hooks on top, then pull the Filter Support.

Filter Support

3 Remove the washable Active Carbon Filter (Black) and HEPA Filter (White) from the plastic bags.

HEPA Filter

Active Carbon Filter

E-6

Image 8

Contents FU-W53J Please read before operating your new Air Purifier English Important Safety Instructions Installation Guidelines Part Names Main Unit DisplayIncluded Remove the Filter Support Filter InstallationRemove the Front Panel Replace the Front Panel Place the Hepa Filter intoMain unit Power ON/OFF Button ION Shower Mode ButtonOperation Main Unit OperationPlasmacluster ON/OFF Button Lights Control ButtonFilter Care and MaintenanceMain Unit Washable Active Carbon Filter Care Hand Wash only Do not Tumble DRYFilter Replacement Guidelines Hepa Filter / Washable Active Carbon FilterTroubleshooting Remedy not a malfunctionSpecifications Standby PowerMemo Memo Memo Sharp Corporation of NEW Zealand Limited