HP 7 Extreme manual Antenna board

Page 29

Antenna board

Description	Spare part number

Antenna board (includes WLAN and GPS antenna cables and transceiver)	745162-001

Before removing the antenna board, follow these steps:

1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.

2.Disconnect the power from the tablet by unplugging the power cord from the tablet.

3.Disconnect all external devices from the tablet.

4.Remove the back cover (see Back cover on page 13).

5.Remove the battery (see Battery on page 15).

6.Remove the left speaker (see Speakers on page 16).

Remove the antenna board:

1.Unsolder the antenna board cables (1) and (2) from the system board antenna connectors.

Antenna board

23

Image 29

Contents HP Slate⁷ Extreme Tablet Product notice Safety warning notice Iv Safety warning notice Table of contents Page Panel Product descriptionProduct description External component identification External component identification Locating the serial number, product number, and model number Illustrated parts catalogComponent Spare part number Tablet major componentsSequential part number listing Miscellaneous parts743207-001 Tools required Removal and replacement preliminary requirementsService considerations Electrostatic discharge damage Grounding guidelinesPackaging and transporting guidelines Equipment guidelines Back cover Removal and replacement proceduresTablet component replacement procedures Page Battery Speakers Page Rear-facing webcamera Page Board Front-facing webcamera Page Antenna board System board Page Page Page Specifications Updating apps, widgets, and the operating system Backing up and recovering your dataBack up and reset Factory data reset Requirements for specific countries and regions Power cord set requirementsRequirements for all countries Power cord set requirements Recycling Jacks Index