Connector board
Description | Spare part number |
|
|
Connector board |
|
|
|
Before removing the connector board, follow these steps:
1.Turn off the tablet. If you are unsure whether the tablet is off, turn the tablet on, and then shut it down through the operating system.
2.Disconnect the power from the tablet by unplugging the power adapter cord from the tablet.
3.Disconnect all external devices from the tablet.
4.Remove the back cover (see Back cover on page 14).
5.Remove the battery (see Battery on page 15).
6.Remove the
7.Remove the
8.Remove the volume and power button board (see Volume and power button board on page 19).
9.Remove the top and bottom speakers (see Speakers on page 19).
10.Remove the antenna board (see Antenna board on page 22).
Remove the connector board:
▲Remove three Torx 4 screws (1) from the display panel assembly, and then remove the connector board
(2).
Reverse this procedure to install the connector board.
24 Chapter 6 Removal and replacement procedures