HP 7 1200, 7+ 1300 manual Power cord set requirements, Requirements for all countries

Page 38

8 Power cord set requirements

The wide-range input feature of the tablet permits it to operate from any line voltage from 100 to 120 volts AC, or from 220 to 240 volts AC.

The 3-conductor power cord set included with the tablet meets the requirements for use in the country or region where the equipment is purchased.

Power cord sets for use in other countries and regions must meet the requirements of the country or region where the tablet is used.

Requirements for all countries

The following requirements are applicable to all countries and regions:

The length of the power cord set must be at least 1.0 m (3.3 ft) and no more than 2.0 m (6.5 ft).

All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the country or region where the power cord set will be used.

The power cord sets must have a minimum current capacity of 10 amps and a nominal voltage rating of 125 or 250 V AC, as required by the power system of each country or region.

The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector for mating with the appliance inlet on the back of the tablet.

Requirements for specific countries and regions

Country/region

Accredited agency

Applicable note number

 

 

 

Australia

EANSW

1

 

 

 

Austria

OVE

1

 

 

 

Belgium

CEBC

1

 

 

 

Canada

CSA

2

 

 

 

Denmark

DEMKO

1

 

 

 

Finland

FIMKO

1

 

 

 

France

UTE

1

 

 

 

32

Chapter 8 Power cord set requirements

Image 38
Contents Compaq 7+ 1300 Tablet and Compaq 7 1200 Tablet Product notice Software termsSafety warning notice Iv Safety warning notice Table of contents Page Product description Operating system Category Description Compaq 7+ Tablet Power requirementsServiceability End user replaceable part External component identification External component identification Illustrated parts catalog Locating the serial number, product number, and model numberComponent Spare part number Back cover Power/volume button board includes cableTablet major components MP rear-facing webcamera includes cableMiscellaneous parts Sequential part number listingSystem memory, and an 8.0-GB Nand flash drive Tools required Removal and replacement preliminary requirementsService considerations Grounding guidelines Electrostatic discharge damagePackaging and transporting guidelines Equipment guidelines Material Use Voltage protection levelBack cover Removal and replacement proceduresTablet component replacement procedures Description Spare part numberPage Battery Antenna board Speaker Rear-facing webcamera Microphone Front-facing webcamera Power/volume button board System board Page Page Specifications Statement of Volatility Select the File menu, then Save Changes and Exit Non-volatile memory usage CmosNon-volatile memory usage Statement of Volatility Questions and answers Requirements for specific countries and regions Power cord set requirementsRequirements for all countries Country/region Accredited agency Applicable note numberRequirements for specific countries and regions Recycling Index JacksTablet
Related manuals
Manual 17 pages 16.65 Kb