Sigma ML750 Program your Keyless Entry Optional, Using the Wall-Mounted Door Control

23

Program your Keyless Entry

1 (optional)

	Activate the opener only when door is in
	full view, free of obstruction and properly
	adjusted. No one should enter or leave
2	garage while door is in motion. Do not
	allow children to operate push button(s)
	or remote(s). Do not allow children to play
	near the door.
3	NOTE: Your new Keyless Entry must be
	programmed to operate your garage door
	opener.
	Program the Receiver to Match Additional
	Remote Control Code
	Using the orange “LEARN” Button:

1.Press and release the orange “learn” button (1) on opener. The learn indicator light will glow steadily for 30 seconds.

2.Within 30 seconds, enter a four digit personal identification number (PIN) of your choice on the keypad (2), then press and hold the ENTER button.

3.Release the button when the opener light blinks (3). It has learned the code. If the light bulb is not installed, two clicks will be

4		heard.
		NOTE: This method requires two people if
		the Keyless Entry is already mounted outside
5		the garage.
LOCK	LIGHT	Using the Multi-Function Door Control:
		4. Enter a	four digit	personal identification
6		number	(PIN) of	your choice on the
		keypad, then press and hold ENTER.

LOCK

LIGHT

LOCK

LIGHT

7

5.While holding the ENTER button, press and hold the LIGHT button on the Multi-Function Door Control.

6.Continue holding the ENTER and LIGHT buttons while you press the push bar on the Multi-Function Door Control (all three buttons are held).

7.Release buttons when the opener light blinks. It has learned the code. If the light bulb is not installed, two clicks will be heard.

24

3	LOCK
	LIGHT

	Using the Wall-Mounted Door Control
	(optional)
	THE MULTI-FUNCTION DOOR CONTROL
	Press the push bar (1) to open or close the door. Press again
	to stop the door.
	Light feature
	Press the Light button (2) to turn the opener light on or off. It
1
	will not control the opener light when the door is in motion. If
	you turn it on and then activate the opener, the light will
	remain on for 2-1/2 minutes. Press again to turn it off sooner.
	Lock feature
2	Designed to prevent operation of the door from hand-held
	remote controls. However, the door will open and close from
	the Door Control, the Outside Keylock and the Keyless Entry
	Accessories.

To activate, press and hold the Lock button (3) for 2 seconds. The push bar light will flash as long as the Lock feature is on.

To turn off, press and hold the Lock button again for 2 seconds.The push bar light will stop flashing. The Lock feature will also turn off whenever the “LEARN” button on the opener panel is activated.

14