ASSEMBLY
5
2
1 |
Assemble the Rail
3
2
4
5
Grease inside edges of rail sections using grease (1). Place rail pieces (2) on flat surface for assembly. All four rail sections are interchangeable. Slide rail brace (3) onto rail section. Connect rail by sliding rail brace onto next rail section. Tap rail assembly (4) on piece of wood (5) until rail sections are flush. Repeat with remaining rail sections.
6
6
8
| Install the Belt |
| Remove belt from carton and lay out on floor (do not allow |
| belt to twist). Hook the trolley connector (6) into the slot (7) |
7 | on the trolley (8). |
Insert Trolley & Idler Pulley Bracket
7 into Rail
Slide idler pulley bracket (1) and inner trolley (2) |
|
into back (opener) end of rail assembly (3), be |
|
sure to insert idler pulley bracket as shown. Arrow |
|
on trolley (7) must face toward front (header) end |
|
of rail (4). Push idler pulley bracket toward front | 7 |
(header) end of rail (4). Insert carriage bolt (5) into |
|
bolt cut out in the idler pulley bracket (6). |
|
4 |
|
6 | 3 |
|
4
1
2
5
5 
5