HP Clustered Gateway Device Management Software manual Mxmpconf manage membership partitions

Chapter 1: Matrix Server Commands 17

mxmpconf – manage membership partitions

Synopsis

/opt/polyserve/bin/mxmpconf

NOTE: Matrix Server cannot be running when you use mxmpconf. To stop the matrix, use the following command:

#/etc/init.d/pmxs stop

Description

The mxmpconf utility starts an ASCII interface that can be used to create a new set of membership partitions or to repair the existing partitions

Membership partitions control access to the SAN and store the device naming database, which includes the global device names for SAN disks imported into the matrix. Each server in the matrix has a membership partition file, which is called the “local MP list.” This file specifies the locations of the membership partitions. Each membership partition also has its own MP list. Because the membership partitions control access to the SAN, it is important that all servers in the matrix have the same view of where the partitions are located. The mxmpconf utility can be used to repair any problems if a failure causes servers to have inconsistent views of the membership partitions.

For detailed information about mxmpconf, see the PolyServe Matrix Server Administration Guide.

Setup Option

The Setup option allows you to create a new set of membership partitions. You can select up to three SAN partitions to be used as membership partitions. It is recommended that the partitions be on separate disks.

Repair Menu

The Repair Menu lists the current membership partitions according to the MP file maintained on the server where you are running the utility.

Membership partitions are either active or inactive. The current membership partitions are active. There can also be old membership partitions in the matrix that are now inactive.

Copyright © 1999-2006 PolyServe, Inc. All rights reserved.