HP UX 11i v2 Networking Software manual 120

Page 120

DLPI Primitives

Connection-mode Service Primitives

dl_reason

reason for the disconnection.

DL_DISC_NORMAL_CONDITION: normal release of a data link connection.

DL_DISC_ABNORMAL_CONDITION: abnormal release of a data link connection.

DL_CONREJ_PERMANENT_COND: a permanent condition caused the rejection of a connect request.

DL_CONREJ_TRANSIENT_COND: a transient condition caused the rejection of a connect request.

DL_UNSPECIFIED: reason unspeciﬁed

dl_correlation

if non-zero, conveys the correlation number that was contained in the DL_CONNECT_IND being rejected. This value permits the DLS provider to associate the primitive with the proper DL_CONNECT_IND when rejecting an incoming connection. If disconnect request is releasing a connection that is already established, or is aborting a previously sent DL_CONNECT_REQ, the value of dl_correlation should be zero.

State

The message is valid in any of the states: DL_DATAXFER, DL_INCON_PENDING, DL_OUTCON_PENDING, DL_PROV_RESET_PENDING, DL_USER_RESET_PENDING.

New State

The resulting state is one of the disconnect pending states, as deﬁned in Appendix B, Allowable Sequence of DLPI Primitives, of the DLPI 2.0 speciﬁcation.

Response

If the disconnect is successful, DL_OK_ACK is sent to the DLS user resulting in state DL_IDLE.

If the request fails, DL_ERROR_ACK is returned, and the resulting state is unchanged.

Reasons for Failure

120

Chapter 2

Image 120

Contents Dlpi Programmer’s Guide EditionLegal Notices Page Page Contents Contents Contents Sample Programs Printing History Page Preface Appendix a Sample ProgramsPage Introduction to Dlpi Introduction to Dlpi HP Dlpi Features Device File Format Header FilesService Interface Data Link LayerDlpi Connection-mode Service Modes of CommunicationData Link Layer Connectionless-mode Service Dlpi AddressingPhysical Attachment Identiﬁcation HP PPA Format Data Link User Identiﬁcation HP’s Dlsap Address Format 802.3, Ethernet, Token Ring, FddiHP’s Dlsap Address Format for Fibre Channel Dlsap Promiscuous Mode Clariﬁcations Dlpi Services Dlerrorack DlinforeqDlinfoack DlhpppareqDlresetreq DlresetindDlresetres DlresetconLocal Management Services Information Reporting ServiceDlhprawdatareq DlhprawdataindAttach Service Bind ServiceBinding Reserved IEEESAPS/EthertypesSnap Message Flow Binding a Stream to a Dlsap Message Flow Enabling a Speciﬁc Multicast Address on a Connection-mode Services Connection Establishment ServiceConnection Handoff 12 Message Flow Successful Connection Establishment13 Message Flow Token Retrieval 16 Message Flow Both Primitives are Destroyed by Provider Data Transfer Service 19 Message Flow Normal Data TransferConnection Release Service 20 Message Flow DLS User-Invoked Connection ReleaseReset Service 23 Message Flow DLS User-Invoked Connection Reset Connectionless-mode Services Connectionless Data TransferRaw-mode Services Error Reporting ServiceXID and Test Service Raw-mode Data Transfer31 Message Flow XID Service XID and Test Packet Handling32 Message Flow Test Service An Example33 Message Flow a Connection-Mode Example Dlpi Primitives Dlpi Primitives Local Management Primitives PPA Initialization/De-initializationDlhpppareq Dlhpppaack Dlhpppaack Dlinforeq MTUDlinfoack Dlcsmacd DltpbDltpr DlmetroDlchar DlctcaDlfddi DlotherDlhprawdls DlacldlsDlunknown DLSTYLE1 DLSTYLE2Dlaccess DlattachreqDlbadppa Dldetachreq DloutstateDlsyserr Dlbindreq Dlbadaddr DlinitfailedDlnotinit Dlbindack Dlunbindreq Dlsubsbindreq Dlpeerbind DlhierarchicalbindDlsubsbindack DltoomanyDlsubsunbindreq Dlenabmultireq Dldisabmultireq DlnotsupportedDlpromisconreq DlnotenabDlpromiscphys DlpromiscsapDlpromiscmulti Dlpromiscoffreq Dlokack Dlerrorack Dlphysaddrreq Dlfactphysaddr Dlcurrphysaddr Dlphysaddrack DlsetphysaddrreqDlphysaddrack DlphysaddrreqDlsetphysaddrreq Dlgetstatisticsreq DlgetstatisticsackDlbusy DlgetstatisticsreqDlhpmulticastlistreq DlgetstatisticsackDlhpmulticastlistack Dlhpmulticastlistack Connectionless-mode Service Primitives DlunitdatareqDlbaddata Dlunitdataind Dluderrorind Message is valid in state Dlidle Raw Mode Service Primitives DlhprawdatareqDlhprawdataind DlbadprimRaw Mode Service Primitives Connection-mode Service Primitives Connection-Oriented Dlpi ExtensionsDlhpinforeq Dlhpinfoack DlhpinforeqDlhpinfoack Connection-mode Service Primitives Connection-mode Service Primitives Dlhpsetacktoreq DlhpsetacktoreqDlhpsetptoreq DlhpsetptoreqDlhpsetrejtoreq DlhpsetbusytoreqDlhpsetrejtoreq Dlhpsetsendacktoreq DlhpsetbusytoreqDlhpsetmaxretriesreq DlhpsetsendacktoreqDlhpsetmaxretriesreq Dlhpsetackthreshreq DLOUTCONPENDING, DlinconpendingDlhpsetlocalwinreq Dlhpsetremotewinreq Dlhpclearstatsreq DlhpsetremotewinreqDlhpsetlocalbusyreq DlhpclearstatsreqDlhpsetlocalbusyreq Dlhpclearlocalbusyreq DlhpclearlocalbusyreqDlconnectreq Dlconnectind DlbadqosparamDlbadqostype 112 Dlconnectres 114 Dlconnectcon DlbadtokenDlbadcorr Dlpending116 Dltokenreq DltokenackDldatareq Dldataind Dldisconnectreq120 Dldisconnectind Dlresetreq Dlresetind Dlresetres Dlresetcon 126 Primitives to Handle XID and Test Operations DltestreqDltestind DltestautoChapter 129 Dltestres Dltestcon Dlxidreq Dlxidind Dlxidauto134 Dlxidres DlpollfinalDlxidcon Chapter 137 Dlpi States User Reset Dluserreset Dlresetcon Prov Reset DlprovresetDlresetres Resetres Udqos Pend DludqosDLDISCON9 Pend PendingDlinconpending DLDISCON11Chapter 141 142 Sample Programs Connection Mode LongareasizeAppendix a 145 146 Appendix a 147 148 Appendix a 149 150 Appendix a 151 152 Appendix a 153 154 Appendix a 155 Connectionless Mode Snap SAPAppendix a 157 158 Appendix a 159 160 Appendix a 161 162 Appendix a 163 164 Appendix a 165 166 Raw Mode 168 Appendix a 169 170 Appendix a 171 Raw Mode 172 Glossary Connection establishment174 Glossary Index

Related manuals

Manual 94 pages 16.8 Kb

Manual 74 pages 39 Kb

Manual 236 pages 18.16 Kb

Manual 12 pages 39.66 Kb

Manual 28 pages 49.76 Kb