HP Distributed Cloud Networking manual HP VSD Installation Using QCow2 Image, Set Up Appliance VMs

mysql -e “update mysql.user set password=PASSWORD <NEW PASSWORD> WHERE USER=’ROOT’; FLUSH PRIVILEGES;”

To change the root password, on each node, run:

mysql -uroot -p<current password> -e “update mysql.user set password=PASSWORD <new password> where user =’root’; flush privileges;”

	Table 1: HP VSD Installation Overview
qcow2		ISO
Set Up Appliance VMs		Set Up VM for ISO
		Extract and Mount ISO Image
	Connect to	Appliance VMs
	Configure Networking
	Configure DNS Server
	Configure NTP Server
Install HP VSD using qcow2		Install HP VSD Using ISO

HP VSD Installation Using QCow2 Image

The following instructions are for a High Availability installation. For a standalone installation, use the same instructions to install one HP VSD on a single node.

1.Set Up Appliance VMs

2.Connect to Appliance VMs

3.Configure Networking

4.Configure DNS Server

5.Configure NTP Server

6.Install HP VSD using qcow2

Set Up Appliance VMs

1.Unzip all the HP VSD tar files to a temporary location.

2.If you do not already have virt-install on your hypervisor(s), run this command to put it in: yum install virt-install

3.Copy the HP VSD qcow2 image to the KVM hypervisor image location <TTY>/var/lib/ libvirt/images/ on each hypervisor.

4.Create appliance VMs.

In the example below, a VM is created for each of four HP VSD nodes. If you are doing a standalone installation, create only myh1.

Note: “listen=0.0.0.0” results in KVM responding to VNC connection requests on all IP interfaces. Depending on your network configuration, this may be a security issue.

HP VSD Installation Using QCow2 Image 13