7)Sleep Mode
a)Press the On/Off key to turn on the remote controller.
b)Press the Sleep key. “Sleep” will appear on the LCD display.
c)Press either /\ of \/ key of the Temperature key until the LCD displays the desired temperature.
d)Press the Fan Speed key until the LCD displays the desired fan speed.
e)Press Timer and Time Adjustment keys until the LCD displays the desired operation hours.
f)Press the Transmit key.
CONDENSATE WATER DRAINAGE
1)Internal Water Tank
When operating in cooling or dehumidifying mode, the condensate water will drain into the internal water tank. Depending on the surrounding humidity, the unit can continuously operate for 2 to 12 hours before the internal water tank is full. When the internal water tank gets full, the LCD window shows error code “E4” and a beep alarm will sound eight times for 15 seconds. The compressor stops running and the fan will continue to run in the set speed for three minutes before the entire unit automatically shuts off.
When the water tank is full, take out the entire water tank slowly and discard the water inside the tank, place it back to its original position. You will then be able to turn on the unit again.
If you want to take out the internal tank before it is full of water, please stop the unit first. Wait for 3 minutes before taking out the water tank to prevent the condensate water from discharging into the unit.
NOTE: Do not take out the water tank when the unit is running on either cooling or dehumidifying mode or the alarm will sound and the compressor stops. The mode will automatically change to FAN mode and the compressor will require approximately 3 minutes to restart to the cooling/dehumidifying cycle.
2)ContinuousDrainage
The unit can operate on continuous drainage mode. When the unit is operating on continuous drainage
11