Soleus Air SG-WAC-25ESE-C THRU-THE-WALL Installation, Installing the Chassis into the Cabinet

Page 11

ASSEMBLY & INSTALLATION (CONT.)

Installing the Chassis into the Cabinet

1.Team lift (two people) the air conditioner chassis and carefully slide it into the cabinet. Let the front of the air conditioner hang out approximately 6”.

2.CAUTION: DO NOT PUSH ON THE CONTROLS OR FINNED COILS.

3.Be sure the chassis is firmly seated in the back of the cabinet.

4.Insert all screws removed during window installation and reattach the front face plate, front panel, and the air filter. Use the REMOVE CHASSIS instructions and figures 1-6 for reference.

THRU-THE-WALL INSTALLATION

NOTE: Consult local building codes prior to installation and/or a qualified carpenter.

Select the Wall Location

This air conditioner has a slide-out chassis, so that it can be installed through an outside wall as specified below:

MAX WALL THICKNESS: 8 1/4”

IMPORTANT: The side louvers must never be blocked.

NOTE: All parts needed for Thru-The-Wall Installation are provided, except a wood frame, shims, and 10 wood screws (10-1” long minimum). Select a wall surface that:

1.Does not support major structural loads such as the frame construction at ends of windows, and under truss-bearing points, etc.

2.Does not have plumbing or wiring inside.

3.Is near existing electrical outlets, or where another out- let can or will be installed.

4.Does not have objects blocking the air vents which limits cooling.

5.Allows unblocked airflow from the rear and sides of the air conditioner.

Prepare the Wall

1.Prepare the wall in frame construction (including brick and stucco veneer). Working from inside the room, find the wall stud that is nearest the center of the installa- tion area.

2.Cut a hole on each side of the center stud.

3.Measure between the inside edges of every other stud as shown below.

FIG. 1

11

Image 11
Contents Models SG-WAC-25ESE-C Important Safety Instructions Recommended Ground Method Lcdi Power Cord and PlugElectrical Requirements Tools Needed Parts ListModel SpecificationsDisclaimer Storm Window Requirements Installation & Assembly InstructionsPrior to Installing the Air Conditioner Window PreparationRemove Chassis Installation & Assembly Instructions Window MountingInstallation & Assembly Instructions Window Mounting Placing the Cabinet Inside the Window Assembly & InstallationTop Angle Rail and Side Bracket Installation TOP ViewMark Install Support BracketsInstall the Window Lock and Sash Seal Extend the Accordion PanelsPrepare the Wall THRU-THE-WALL InstallationInstalling the Chassis into the Cabinet Select the Wall LocationPrepare and Install the Cabinet Assembly & Installation THRU-THE-WALLSupport Bracket Wooden Strip Masonry ConstructionAir Conditioner Controls Normal Operating Sounds Using Your AIR ConditionerElectronic Control Panel & Remote Control Operating Your AIR Conditioner Remote ControlOperating Your AIR Conditioner Using Your AIR Conditioner Winter Storage Care and CleaningAir Filter Cleaning Cabinet CleaningProblem Possible Causes Solutions TroubleshootingWater collects in the base pan Water is dripping outsideWater is dripping inside the room One Year Limited Warranty Warranty