Using Your AIR Conditioner

Electronic Control Panel & Remote Control

NOTE: This display always shows the room temperature except when setting the Set temperature or the Timer.

When the light is on the unit is in temperature or timer set mode.

Air Conditioner Controls

Normal Operating Sounds

•You may hear a pinging noise caused by water hitting the condenser, on rainy days, or when the humidity is high. This design feature helps re- move moisture and improve efficiency.

•You may hear the thermostat click when the com- pressor cycles on and off.

•Water will collect in the base pan during rain or days of high humidity. The water may overflow and drip from the outside part of the unit.

•The fan may run even when the compressor is not on.

1.Power Button: Turns the air conditioner on and off

2.Digital Display: Displays the current room tem- perature or the amount of time left on the timer. Shows the Set Temp when setting the tempera- ture. Shows the Timer Set when setting the timer. The once the timer and/or temperature are set, the display will change to show the current room temperature. To see the set temperature again, simply press either of the Temp/Delay ▲/▼ buttons.

3.Temperature Set: Use these buttons on the con- trol panel and remote to increase or decrease the Set Temperature (the desired room temperature) in cooling or energy saver mode. The SET light will light up when setting the temperature

4.Timer Set: Use these buttons on the control panel and remote to set the Timer. Each press of the Timer (DELAY) buttons will increase or de- crease the timer. For timer instructions see #7.

5.Fan Speed & Auto Fan: Use the fan speed but- tons to change the fan speed. Choose between low, medium, high, and Auto. When using the re- mote control, press the AUTO button to turn auto mode on and off and the FAN+ and FAN– buttons to select low, medium, or high fan speed.

6.Mode Button: Press the mode button to cycle

through the various modes: Cooling, Energy Saver, Fan only, and Dry (Dehumidifier).

7.Auto-on Timer: When the air conditioner is off, it can be set to automatically turn on in 1-24 hours at the previous set mode and fan setting. To set the Auto-on Timer, press the TIMER button on the unit or remote control. Each touch of the ▲/▼ on the unit or the +/- buttons on the remote will change the timer setting in 1 hour intervals. The SET light will turn on while setting.

Auto-off Timer: When the air conditioner is on, it can be set to automatically turn off in 1-24 hours. To se the Auto-off Timer, press the TIMER button on the unit or remote control. Each ouch of the ▲/ ▼ on the unit or the +/- buttons on the remote will change the timer setting in 1 hour intervals. The SET light will turn on while setting.

•To see the remaining time, press the TIMER Button. To change the timer setting use the ▲/▼ on the unit or the +/- buttons on the remote.

•To cancel the timer, press the TIMER button until the SET light turns off.

8.Filter Check: After the fan rotates for 250 total hours, the filter check light will turn on to remind the user to clean the filter. Press the Filter check button once the filter is cleaned to reset the re- minder.