Soleus Air SG-WAC-25ESE-C Masonry Construction, Support Bracket Wooden Strip

Page 13

ASSEMBLY & INSTALLATION - THRU-THE-WALL (CONT.)

Refer to the SUPPORT BRACKET ASSEMBLY in the WINDOW MOUNTING section to assemble the support brackets. A wooden strip nailed to the outside wall should be used in conjunction with the angled sill support brack- ets.

FIG. 3

Support

Bracket

Wooden Strip

5.Screw or nail the cabinet to the wooden frame using shims if the frame is oversized, to eliminate possible noise. Remember to maintain proper slope for water elimination.

FIG. 4

MASONRY CONSTRUCTION

1.Cut or build a wall opening in the masonry wall similar to the frame construction (refer to the THRU-THE- WALL installation for a wall thickness greater than 8 1/2”)..

2.Secure the cabinet in place using masonry nails, or masonry anchor screws. Or, build a frame using the instructions found in the THRU-THE-WALL installation section.

3.Make sure the masonry above the cabinet is supported well. Use the existing holes in the cabinet or additional drilled holes to fasten the cabinet at various positions.

Make sure that the side louvers are clear of any ob- structions.

4.Install the exterior cabinet support brackets according to the SUPPORT BRACKET INSTALLATION instruc- tions in the THRU-THE-WALL installation section.

Caulk or flash with aluminum if needed. This will pro- vide a tight seal around the top and sides of the cabi- net.

5.For a more aesthetically pleasing installation, apply wood trim molding around the sides of the cabinet with- out obstructing the side louvers.

6.Install the chassis into the cabinet by following the steps described in the WINDOW MOUNTING section.

OPTIONAL: Caulking and installation of the trim on the interior wall may be done if desired. Caulk the openings around the top and sides of the cabinet and all sides of the wood sleeve to the opening.

NOTE: See the WINDOW MOUNTING instructions for the bottom rail seal location.

13

Image 13
Contents Models SG-WAC-25ESE-C Important Safety Instructions Electrical Requirements Lcdi Power Cord and PlugRecommended Ground Method Tools Needed Parts ListDisclaimer SpecificationsModel Prior to Installing the Air Conditioner Installation & Assembly InstructionsWindow Preparation Storm Window RequirementsRemove Chassis Installation & Assembly Instructions Window MountingInstallation & Assembly Instructions Window Mounting Top Angle Rail and Side Bracket Installation Assembly & InstallationTOP View Placing the Cabinet Inside the WindowInstall the Window Lock and Sash Seal Install Support BracketsExtend the Accordion Panels MarkInstalling the Chassis into the Cabinet THRU-THE-WALL InstallationSelect the Wall Location Prepare the WallPrepare and Install the Cabinet Assembly & Installation THRU-THE-WALLSupport Bracket Wooden Strip Masonry ConstructionElectronic Control Panel & Remote Control Using Your AIR ConditionerAir Conditioner Controls Normal Operating Sounds Operating Your AIR Conditioner Remote ControlOperating Your AIR Conditioner Using Your AIR Conditioner Air Filter Cleaning Care and CleaningCabinet Cleaning Winter StorageProblem Possible Causes Solutions TroubleshootingWater is dripping inside the room Water is dripping outsideWater collects in the base pan One Year Limited Warranty Warranty