HP DL120 manual Server Power Cords North America, Power Supply

QuickSpecs

HP ProLiant DL120 Generation 6

Standard Features

Server Power Cords North America	One 6' Highline (IEC-IEC) power cord ships standard
Japan	One 6' Highline (IEC) power cord and one 6' Lowline power cord ship
	standard
ROW	One 6' Highline (IEC) power cord ships standard

NOTE: HP ProLiant DL120 G6 server ship standard worldwide with a C13 to C14 2M Highline jumper cord. Japanese models also include a 2M Lowline power cord. If customers require a local power cord, they can check the power cord matrix for the appropriate country specific cord. Please see the following power cord matrix: http://www.hp.com/go/powercordmatrix.

Power Supply Auto-sensing 400-Watt PFC Power Supply, CE Mark Compliant

UPS and PDU Power Please see the UPS and PDU cable matrix's on the HP Power Protection and Management page.

Cord Matrix Under Power Cords, click on the "HP Power Cord Matrix" link. That link will list cable descriptions, requirements, and specifications for UPS and PDU units. Please see the following link: www.hp.com/products/powercords.

System Fans 4 dual rotor fans ship standard.

Required Cabling For required cabling information, refer to the Web site at: http://h10010.www1.hp.com/wwpc/us/en/sm/WF05a/15351-15351-3328412-241644-241475- 3579703.html.

Operating Systems and Microsoft Windows Server

Virtualization Software Red Hat Enterprise Linux (RHEL)

SUSE Linux Enterprise Server (SLES)

NOTE: For more information on HP's Certified and Supported ProLiant Servers for OS and Virtualization Software and latest listing of software drivers available for your server, please visit our Support Matrix at: http://www.hp.com/go/supportos and our driver download page http://www.hp.com/support/DL120G6

Rack Airflow	Rack 10000 G2 series Cabinets
Requirements	The increasing power of new high-performance processor technology requires increased cooling
	efficiency for rack-mounted servers. The 10000 G2 Series Racks provide enhanced airflow for
	maximum cooling, allowing these racks to be fully loaded with servers using the latest processors.
	CAUTION: If a third-party rack is used, observe the following additional requirements to ensure
	adequate airflow and to prevent damage to the equipment:
	Front and rear doors: If your 42U server rack includes closing front and rear doors, you must
	allow 830 square inches (5,350 sq cm) of hole evenly distributed from top to bottom to
	permit adequate airflow (equivalent to the required 64 percent open area for ventilation).
	Side: The clearance between the installed rack component and the side panels of the rack
	must be a minimum of 2.75 inches (7 cm).
	CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack.
	This arrangement ensures proper airflow. Using a rack without blanking panels results in improper
	cooling that can lead to thermal damage.
	NOTE: For additional information, refer to the Setup and Installation Guide or the Documentation
	CD provided with the server.

DA - 13504 Worldwide QuickSpecs — Version 8 — 8/20/2010 Page 9