HP DL120 manual Technical Specifications

QuickSpecs

HP ProLiant DL120 Generation 6

Technical Specifications

System Unit	Dimensions (H x W x D) 4.32 x 44.81 x 70.0 mm (1.69" x 17.64" x 27.56")
	(with bezel)
	Weight	Maximum	31.49 lb (14.3kg)
	(approximate)	(four hard drives, power
		supply, and processor
		installed)
		Minimum	28.2lb (12.8kg)
		(one hard drive, power
		supply, and processor
		installed)
	Input Requirements	Range Line Voltage	90 - 132 VAC,
	(per power supply)		180 - 264 VAC
		Rated Input Current	6 A (at 100 VAC),
			3 A (at 200 VAC)
		Rated Input Frequency	47 to 63 Hz
		Rated Input Power	<550W (at 100 VAC)
			550W (at 200 VAC)
	BTU Rating	Maximum	1314 BTU/hr (at 100 VAC),
			1314 BTU/hr (at 200 VAC)
	Power Specifications	To review typical system power ratings use the Power Advisor which is
		available via the online tool located at URL: www.hp.com/go/proliant-
		energy-efficientor www.hp.com/go/hppoweradvisor
		- Click on the system of interest. Example: DL120 G6
		- Follow the instructions of the next screens.
	Power Supply Output	Rated Steady-State	400 W (at 100 VAC),
	(per power supply)	Power	400 W (at 200 VAC)
		Maximum Peak Power	430 W (at 100 VAC),
			430 W (at 200 VAC)
	System Inlet	Operating	10° to 35°C (50° to 95°F) at sea level with an
	Temperature		altitude derating of 1.0°C per every 305 m
			(1.8°F per every 1000 ft) above sea level to a
			maximum of 3050 m (10,000 ft), no direct
			sustained sunlight. Maximum rate of change
			is 10°C/hr (18°F/hr). The upper limit may be
			limited by the type and number of options
			installed.
			System performance may be reduced if
			operating with a fan fault or above 30°C
			(86°F).
		Non-operating	-30° to 65°C (-22° to 149°F). Maximum rate of
			change is 20°C/hr (36°F/hr).
	Relative Humidity	Operating	10 to 90% relative humidity (Rh), 28°C
	(non-condensing)		(82.4°F) maximum wet bulb temperature, non-
			condensing.
		Non-operating	5 to 95% relative humidity (Rh), 38.7°C
			(101.7°F) maximum wet bulb temperature,
			non-condensing.
	Altitude	Operating	3050 m (10,000 ft). This value may be limited
			by the type and number of options installed.
			Maximum allowable altitude change rate is
			457 m/min (1500 ft/min).
		Non-operating	9144 m (30,000 ft). Maximum allowable
			altitude change rate is 457 m/min (1500
			ft/min).

DA - 13504 Worldwide QuickSpecs — Version 8 — 8/20/2010 Page 30