Using Your Air Conditioner

Manual Control Panel

Operating Your Air Conditioner

1.Power: Turn on the unit by rotating the MODE dial to the desired setting.

2.Cooling Mode: For maximum cooling set the MODE dial to “HIGH COOL”. In HIGH COOL mode, the fan will automatically go to high.

This will help circulate the cool air throughout the room. The fan will operate on low in “LOW COOL” mode

3.Fan Mode: For fan only modes, choose either HIGH FAN or LOW FAN. The air conditioner will not cool the room when in fan mode.

4.Thermostat: Turn the TEMP dial to set the desired room temperature. For maximum cooling turn the TEMP dial to 7 (coolest).

5.Directional Louvers: To direct the airflow, rotate the small vertical louver wheel next to the air vent on the front of the air conditioner

LOUVER WHEEL

NOTE: To minimize wear and tear on the air conditioner, always wait at least 3 minutes before changing modes. This will help prevent the compressor from overheating and the circuit breaker from tripping.

Normal Operating Sounds

•You may hear a pinging noise caused by water hitting the condenser, on rainy days, or when the humidity is high. This design feature helps remove moisture and improve efficiency.

•You may hear the thermostat click when the compres- sor cycles on and off.

•Water will collect in the base pan during rain or days of high humidity. The water may overflow and drip from the outside part of the unit.

•The fan may run even when the compressor is not on.