HP MPEGscope manual General

Page 33

Specifications

General

General

Performance

Transmitting from disk:

Minimum: 250

Kb/s

 

 

 

Maximum: 85

Mb/s for E6277B, E6277C, E6300A, E6301A,

 

 

 

 

 

E6302A

 

 

 

 

 

60

Mb/s for E6277A

 

Recording to disk:

Up to 85

Mb/s for E6277B, E6277C, E6300A, E6301A, E6302A

 

 

 

Up to 60

Mb/s for E6277A

Real-time analysis:

42.5Mb/s (including null packets) with the restriction that the PSI and SI table rates are less than 2 Mb/s

Capacity

Multi–program transport stream (MPTS) can be recorded or transmitted

 

Real–time measurements are performed on one transport stream

 

Real–time measurements can occur simultaneously with recording to disk or transferring from disk

 

up to 9 (or 18) GB of data can be recorded, depending on size of streaming disk. (18 GB streaming

 

 

disk is Option E6277B Opt 518)

Bus type

PCI/ISA

External clock

50 nominal, terminated to ground

 

Level: 1 V p—p unbalanced

 

Frequency range: 33 kHz to 66 MHz

 

Connector: SMB

 

Duty cycle: better than 55/45%

 

Can be used by the transmit ports

27 MHz reference

High impedance

clock

Level: TTL

 

Connector: SMB

Duty cycle: better than 55/45%

Can be used as a measurement reference for the real–time analyzer

A-5

Image 33
Contents MPEGscope Startup Guide Pentium Acrobat Printing history Copyright Warranty MPEGscope MicrosoftManual Name Product NumberIndicates that antistatic precautions should be taken Safety SymbolsCertification Additional Information for Test and Measurement EquipmentAvertissement Symboles de sécuritéAvertissement Cet instrument est conforme auxPage Page Page Contents Page Introduction For More Information How To Contact UsMaterials shipped with your MPEGscope system System to enable you to become quickly productiveIntroduction For More Information For More InformationHow To Contact Us Getting Started Starting an MPEGscope Test Session Software, refer to Appendix B, Reinstalling SoftwareGetting Started Starting an MPEGscope Test Session Getting Started Connecting to Interfaces Connecting to InterfacesGetting Started Connecting to Interfaces To Connect to the DVB-SPI Interface To Connect to the ASI and Serial ECL Dhei Interface M2S ModeConnect the Amplimite TM HD-22 Getting Started Connecting to Interfaces Dhei InterfaceDVB-SPI Rx To Connect to the Smpte 310M InterfacePort on the MPEGscope Main Board. Outspi To Connect to the Arib InterfaceGetting Started Connecting an External Clock Source Connecting an External Clock SourceConnecting an External Trigger Cable Setup dialog for instructionsTo see the list of relevant topics Getting Started Troubleshooting TroubleshootingSelect Start Technical A-2 General A-5 Line Interface A-6 SpecificationsTechnical Service information Specifications TechnicalSI in DVB systems BroadcastingStream, September CircuitsDecember 2000General Line Interface 16 Mb/s Type Biphase markClock 100 ns PacketsSPI 25b PinDHEId EXP INeGND Signal Arib in connectorPin ARIBa Data TPD7 MSB Data TPD6 Data TPD5 Page Reinstalling Software Reinstalling Software Reinstalling SoftwareReinstalling Software Performing a System Backup Performing a System BackupReinstalling Software Performing a System Restore Performing a System RestoreIndex-1 CablesTop margin for text Index-2