Step 5 – Install Printheads
3. Remove all four ink cartridges from their packaging and insert each ink cartridge into its own
Step 5 – Install Printheads
In the online edition, click to see a video clip of the following procedure:
1. Make sure that the Ink Cartridge Door is open. Grasp the side of the Printhead Access Cover and lift up firmly to snap the cover open and completely remove it from the printer. You may have to use some force to open the cover.
Note: If the cradle cannot be found under the cover, it means that the tape securing the cradle has not been removed. Open the top cover, remove the tape securing the cradle, turn off the printer and turn on again.
2.Make sure the printer is turned ON.
Open the purple printhead latch by lifting the latch from the rear. Pull the latch forward and down to release the latch hook from the purple carriage lock. Then lift and push the latch toward the back of the printer.
3. Remove each printhead from its package.
Remove the protective tape from each printhead.
HP DesignJet ColorPro Series: Getting Started Guide 6